1 September 2016 in Applied Energy
1 January 2018 in The Journal of the Acoustical Society of America
JVJean-Christophe Valière
The influence of both the natural convection and end-effects on Rayleigh streaming pattern in a simple standing-wave thermoacoustic engine is investigated experimentally at different acoustic levels. The axial mean velocity inside the engine is measured using both Laser Doppler Velocimetry and Particle Image Velocimetry. The mean flow patterns are categorized in three different regions referred to as “cold streaming” region, “hot streaming” region, and “end-effects” region. In the cold streaming region, the dominant phenomenon is Rayleigh streaming and the mean velocity measurements correspond well with the theoretical expectations of Rayleigh streaming at low acoustic levels. At higher acoustic levels, the measurements deviate from the theoretical expectations which complies with the literature. In the hot streaming region, temperature measurements reveal that the non-uniformity of the resonator wall temperature is the origin of natural convection flow. Velocity measurements show that natural convection flow superimposes on the Rayleigh streaming flow so that the measured mean velocity deviates from the theoretical expectations of Rayleigh streaming. In the last region, the measured mean velocity is very different from Rayleigh streaming due to the combined effects of both the flow disturbances generated near the extremity of the stack and the natural convection flow.
1 November 2022 in The Journal of the Acoustical Society of America
Noise generation by low Mach number air flows through circular orifices in rectangular ducts is investigated. In particular, the influence of the number and position of the orifices maintaining a constant flow area is addressed. A review of the available theories suggests a certain importance of such parameters in the excitation of higher-order acoustic duct modes. A qualitative coefficient is proposed for a first characterization of the ability to enhance or lessen a given higher-order acoustic mode by the plate geometry. An experimental campaign is performed to measure the total emitted acoustic power by different plate geometries as well as its modal composition. It is found that the orifices' numbers and positions greatly influence the acoustic emissions while the flow pressure drop caused by the obstacles is similar. The proposed qualitative coefficient shows good agreement with the experimental results. A particle image velocimetry measurement campaign is performed to visualize the near-field average flow behavior upstream and downstream of the orifice plates. An increase in the turbulent velocity fluctuations in the vicinity of the orifices is observed on both sides, further validating previous studies on the subject.
1 February 2021 in The Journal of the Acoustical Society of America
The aim of this study is to investigate the oscillating flow velocity field at the exit of different stacked mesh grid regenerators using Particle Image Velocimetry measurements. Twelve different experimental cases are discussed, yielding oscillating flow fields at the exit of four kinds of regenerators for different acoustic levels. The regenerators are classified according to the mesh wire size to viscous penetration depth ratio and according to the method of stacking the mesh grids. Based on the analysis of the vorticity fields at the exit of the regenerator, three groups of flow patterns are identified. This classification is correctly verified by using the Reynolds number (based on the acoustic amplitude and wire diameter) and the Strouhal number (based on the acoustic displacement amplitude and wire diameter). The characteristics of the fluctuating velocity components are investigated for these various flow patterns. The critical Reynolds number, past which the flow is highly dissipative, is determined. The dissipation timescale is investigated and the quasi-steady approximation is found to be valid for the analysis of the oscillating flow at the exit of the regenerator mesh.
6 September 2023 in Flow Measurement and Instrumentation
1 October 2021 in The Journal of the Acoustical Society of America
A calculation method is proposed to investigate trapped modes in a rigid waveguide with rigid obstacles in the presence of non-potential steady mean flow in a two-dimensional coordinate system. This method facilitates the investigation of trapped modes in the presence of non-potential flow. A coupled calculation method that combines computational fluid dynamics and computational aeroacoustics is used. Galbrun's equation of aeroacoustics is used and discretized by the finite element method. The boundary condition corresponding to the unbounded domain is modeled by the perfectly matched layer technique. The proposed approach facilitates the investigation of the trapped modes generated by obstacles with different geometrical shapes. The effects of both the dimensions of different geometrical shapes (e.g., thin plate, rectangular, and elliptical) and the presence of the non-potential flow on the trapped modes are studied. It is observed that the non-potential flow alters the pressure distribution around the obstacle and the frequencies of the trapped modes. The results show good agreement with the literature. Also, experimental investigations are performed to validate the model.