Clemens Suter

Clemens Suter

Auto-generated profile, based on publicly available information

Clemens Suter

Department of Mechanical and Process Engineering, ETH Zürich, 8092 Zürich, Switzerland

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 April 2010 in Materials
Verified
Journal Article
Open access
PDF file
PTPetr Tomeš
Petr Tomeš
MTMatthias Trottmann
Matthias Trottmann
CSClemens Suter
Clemens Suter
MAMyriam Haydée Aguirre
Myriam Haydée Aguirre
ASAldo Steinfeld
Aldo Steinfeld
AWAnke Weidenkaff
Anke Weidenkaff
The direct conversion of concentrated high temperature solar heat into electrical energy was demonstrated with a series of four–leg thermoelectric oxide modules (TOM). These temperature stable modules were not yet optimized for high efficiency conversion, but served as proof-of-principle for high temperature conversion. They were constructed by connecting two p- (La1.98Sr0.02CuO4) and two n-type (CaMn0.98Nb0.02O3) thermoelements electrically in series and thermally in parallel. The temperature gradient ΔT was applied by a High–Flux Solar Simulator source (HFSS) which generates a spectrum similar to solar radiation. The influence of the graphite layer coated on the hot side of the Al2O3 substrate compared to the uncoated surface on ΔT, Pmax and η was studied in detail. The measurements show an almost linear temperature profile along the thermoelectric legs. The maximum output power of 88.8 mW was reached for a TOM with leg length of 5 mm at ΔT = 622 K. The highest conversion efficiency η was found for a heat flux of 4–8 W cm-2 and the dependence of η on the leg length was investigated.

14 April 2010 in Materials
Verified
Journal Article
Open access
PDF file
CSClemens Suter
Clemens Suter
PTPetr Tomeš
Petr Tomeš
AWAnke Weidenkaff
Anke Weidenkaff
ASAldo Steinfeld
Aldo Steinfeld
A heat transfer model that couples radiation/conduction/convection heat transfer with electrical potential distribution is developed for a thermoelectric converter (TEC) subjected to concentrated solar radiation. The 4-leg TEC module consists of two pairs of p-type La1.98Sr0.02CuO4 and n-type CaMn0.98Nb0.02O3 legs that are sandwiched between two ceramic Al2O3 hot/cold plates and connected electrically in series and thermally in parallel. The governing equations for heat transfer and electrical potential are formulated, discretized and solved numerically by applying the finite volume (FV) method. The model is validated in terms of experimentally measured temperatures and voltages/power using a set of TEC demonstrator modules, subjected to a peak radiative flux intensity of 300 suns. The heat transfer model is then applied to examine the effect of the geometrical parameters (e.g. length/width of legs) on the solar-to-electricity energy conversion efficiency.