Oleh Voznyak

Oleh Voznyak

Auto-generated profile, based on publicly available information

Oleh Voznyak

Lviv Research Institute of Forensic Expertise of the Ministry of Justice of Ukraine

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 November 2018 in MATEC Web of Conferences
Verified
Journal Article
Open access
AKAndriy Kuzyshyn
Andriy Kuzyshyn
ABAndriy Batig
Andriy Batig
SKSergei Kostritsa
Sergei Kostritsa
JSJulia Sobolevska
Julia Sobolevska
VKVitalii Kovalchuk
Vitalii Kovalchuk
OVOleg Voznyak
Oleg Voznyak
The problem of the interaction of rolling stock with the rail track has been analyzed in the present paper. It has been established that in the process of transport science development a number of methods for determining the causes of wheel pairs derailment are developed, which, in a varying degree, take into account the peculiarities of their interaction. The problem of choosing the most accurate method for estimating the causes of rolling stock derailment becomes more complicated because of the lack of sufficient experimental data that would allow us to verify the adequacy of the models. The indicators of stability of the wheel against derailment, which are used on the railways of Ukraine and Europe, have been examined. Their dependences on the speed of movement were derived. It has been established that the increase of the speed of motion leads to the increase of the interaction power of the rolling stock with the rail track, which may, under certain operational parameters, provoke its derailment. As a result of the calculations, it has been shown that the use of norms for car design and calculation used on Ukrainian railways can lead to an inadequate estimation of traffic safety parameters, since it does not take into account the unevenness of the railway track. It has been established that the requirements of BS EN 14363: 2005 European norms are stricter in comparison with the norms for calculation and evaluation of the bearing elements strength and dynamic qualities of motor-vehicle rolling stock used on Ukrainian railways. A comparison of the experimentally and theoretically calculated values of the stability margin coefficient against wheel derailment of the first wheel pair of the diesel train car was carried out.

30 April 2021 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
VKVitalii Kovalchuk
Vitalii Kovalchuk
AOArtur Onyshchenko
Artur Onyshchenko
OFOlexander Fedorenko
Olexander Fedorenko
MHMykola Habrel
Mykola Habrel
BPBogdan Parneta
Bogdan Parneta
RRRoman Rybak
Roman Rybak
This paper reports the full-scale experimental measurements of temperature distribution over the surfaces of bridges' steel-concrete beams under the influence of positive and negative ambient temperatures. It has been established that the temperature is distributed unevenly along the vertical direction of a bridge's steel-concrete beam. It was found that the metal beam accepted higher temperature values. The maximum registered temperature difference between a metal beam and a reinforced concrete slab at positive ambient temperatures was +9.0 °C, and the minimum temperature difference was −2.1 °C. The mathematical models for calculating a temperature field and a thermally strained state of bridges' steel-concrete beams under the influence of variable climatic temperature changes in the environment have been improved, taking into consideration the uneven temperature distribution across a bridge's reinforced concrete beam. The possibility has been established to consider a one-dimensional problem or to apply the three-dimensional estimated problem schemes as the estimation schemes for determining the thermo-elastic state of reinforced concrete bridges. The temperature field and the stressed state of bridges' reinforced concrete beams were determined. It was found that the maximum stresses arise at the place where a metal beam meets a reinforced concrete slab. These stresses amount to 73.4 MPa at positive ambient temperatures, and 69.3 MPa at negative ambient temperatures. The amount of stresses is up to 35 % of the permissible stress values. The overall stressed-strained state of a bridge's reinforced concrete beams should be assessed at the joint action of temperature-induced climatic influences and loads from moving vehicles

27 December 2019 in The Baltic Journal of Road and Bridge Engineering
Verified
Journal Article
Open access
PDF file
Mykola SysynMykola Sysyn
Mykola Sysyn
VKVitalii Kovalchuk
Vitalii Kovalchuk
ONOlga Nabochenko
Olga Nabochenko
YKYuri Kovalchuk
Yuri Kovalchuk
OVOleg Voznyak
Oleg Voznyak
Reliable and durable operation of the railway track under the dynamic load of the rolling stock depends considerably on the ability of the ballast layer to get the load from the sleepers and distribute it to the subgrade. In this paper, the experimental study of the distribution properties of the ballast layer under the impact of dynamic loading depending on the density of the ballast layer is carried out. The ballast behaviour during load cycles is estimated by pressure measurements at the ballast prism base along the axis of a sleeper with simultaneous video observation of the ballast particles movement through transparent sidewalls of the box with crushed stone. Measurements of pressure distribution are carried out with the developed microcontroller system of measurements and developed load cells. The system allows performing multi-point measurements of stress in combination with measurements of acceleration and photogrammetry. The results of measurements showed a significant effect of the ballast layer consolidation on the distribution of stresses under the sleeper. The performed research opens up opportunities for practical improvement of the existing types of track structures and the technology of the ballast layer tamping in terms to provide the optimal conditions for the ballast layer operation.

1 October 2019 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
AKA Kuzyshyn
A Kuzyshyn
SKS Kostritsa
S Kostritsa
LUL Ursulyak
L Ursulyak
ABA Batig
A Batig
JSJ Sobolevska
J Sobolevska
OVO Voznyak
O Voznyak
The paper studies the possibility of using previously developed by the authors spatial mathematical model of the modern diesel train DPKr-2 for parameters determination, with the help of which the dynamic properties of the mechanical part are evaluated. The dependences of maximum accelerations of the body in the vertical and horizontal planes, the coefficients of vertical and horizontal dynamics both in the primary and in the secondary suspension on the speed of the car movement, the amplitude and the length of geometrical unevenness of the railway track were obtained. It is established at what speeds, depending on the parameters of geometrical unevenness of the railway track, the phenomenon of resonance and danger for the diesel train car movement appears. For a particular length of geometrical unevenness, the maximum permissible value of its amplitude over the entire range of speed movement, where the coefficients of vertical and horizontal dynamics in the primary suspension do not exceed permissible limits, has been studied. The adequacy of the mathematical model is checked by comparing the results obtained during calculations with the experimental ones.

28 April 2022 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
VKVitalii Kovalchuk
Vitalii Kovalchuk
YSYuliya Sobolevska
Yuliya Sobolevska
AOArtur Onyshchenko
Artur Onyshchenko
OBOlena Bal
Olena Bal
IKIvan Kravets
Ivan Kravets
OVOleh Voznyak
Oleh Voznyak
This paper has analyzed the use of fiberglass pipes in the body of the railroad embankment by a method of pushing them through the subgrade. A flat rod model has been improved for assessing the deformed state of the transport structure "embankment-fiberglass pipe" by a method of forces when replacing the cross-section of the pipe with a polygonal one. The analytical model accounts for the interaction between the pipe and soil of the railroad embankment. To this end, radial and tangential elastic ligaments are introduced into the estimation scheme, which make it possible to simulate elastic soil pressure, as well as friction forces that occur when the soil comes into contact with the pipe. The deformed state of the transport structure "embankment-fiberglass pipe" was calculated by the method of forces and by a finite-element method under the action of load from the railroad rolling stock, taking into consideration the different cross-sections of the pipe. It has been established that with an increase in the diameter of the fiberglass pipe, the value of deformations of the subgrade and fiberglass pipe increases. With a pipe diameter of 1.0 m, the deformation value in the vaulted pipe is 2.12 mm, and with a pipe diameter of 3.6 m – 4.16 mm. At the same time, the value of deformations of the subgrade under the sleeper is 5.2 mm and 6.0 mm, respectively. It was determined that the maximum deformations of the subgrade, which occur above the pipe, with a pipe diameter of 3.6 m, are 4.46 mm. At the same time, the maximum vertical deformations of a fiberglass pipe arise in the pipe vault and, with a pipe diameter of 3.6 m, are 4.16 mm. It has been established that the maximum horizontal deformations of the subgrade occur at points of horizontal diameter of the fiberglass pipe while the minimal horizontal deformations of the subgrade occur at points lying on the vertical diameter of the pipe

25 February 2016 in Science and Transport Progress
Verified
Journal Article
Open access
PDF file
VHV. I. Havryliuk
V. I. Havryliuk
OVO. M. Voznyak
O. M. Voznyak
VMV. V. Meleshko
V. V. Meleshko
IMPROVING THE POSITIONING ACCURACY OF TRAIN ON THE APPROACH SECTION TO THE RAILWAY CROSSING