2 February 2018 in Journal of Materials Science
10 September 2019 in Ferroelectrics
Nanoparticles (NPs) from anthropogenic sources are discharged into receiving water and increase the exposure to plants, microorganisms, animals, and humans. For removing NPs in dispersion-stabilized nanofluids, four methods were used in this paper including regulating pH, adjusting electrolyte concentration, adding coagulant AlCl3 and centrifugation. The residual concentration (RC) of MWCNTs and 95%MWCNTs NPs were 17.39% and 70.07%, respectively, as pH 1.46 in MWCNTs nanofluid and 1.61 in 95%MWCNTs nanofluid. The RC of NPs less than 10% with NaCl for 200mM and 300mM, or CaCl2 for 1.5mM and 1.2mM in MWCNTs and 95% MWCNTs nanofluid, respectively. 0.05mM AlCl3 was added into MWCNTs or 95% MWCNTs nanofluid that RC decreased to 20%. Higher than 2000×g and 9000×g force centrifugal in the disposal of GNP and SWNTs nanofluids, respectively, the RC maintained between 10% and 20%.
1 January 2019 in The Proceedings of the International Conference on Nuclear Engineering (ICONE)
Cruciform control rod is a key component of nuclear heating reactor (NHR). Unlike the conventional "absorber-rod & cladding-sheet" design, Integral-Plate cruciform control rod has two perpendicular absorber plates to form the cross wing. Each plate is made of a stainless steel panel with several hundreds of holes drilled on each flank to contain B4C absorber elements. Longitudinal groove is made at the middle of the plate. Then the two plates can intersect each other. Compared to the "absorber-rod & cladding-sheet" design, integral-plate cruciform control rod can achieve a reduction of weight and enhancement of mechanical strength, and easier to fabricate which means lower price. Structural features of the new type cruciform control rod are shown in this paper. Comparison of absorber load of the two designs is also discussed. Finite element analysis is done to determine the mechanical behavior of the control rod under a fast drop impact.