19 July 2018 in Water Resources Research
Evaporation is a significant part of the water cycle in hyper‐arid environments. The subsurface of these deserts is characterized by deep groundwater with negligible recharge, whereby water flows from the water table to the surface and evaporates. We propose an analytical model to predict the evaporation rate and the position of the evaporative front. The model accounts for water table depth, atmospheric conditions, and soil hydraulic properties. We consider steady state flow, with two distinct regions separated by an evaporative front, liquid‐phase flow from the water table to the front and vapor‐phase flow from the front toward the surface. The driving forces are pressure head gradients for Darcian liquid flow, and thermal and relative humidity gradients for Fickian diffusive vapor flow. Evaporation rates are predicted for different soil types. The impact of constitutive models applied for characterizing these soils, groundwater depth, and atmospheric conditions are evaluated. Evaporation increases as groundwater levels are shallower, and as atmospheric temperatures increase and/or relative humidity values decrease. Evaporation decreases exponentially with groundwater depth, approaching a constant value of about 0.02 mm per year under typical atmospheric conditions and water table depths below 500 m. The impact of soil type and other related uncertainties are important when groundwater is shallower than 300 m. The relative portion of the liquid phase region increases compared to that of the vapor one as evaporation rates increase. The actual size of the liquid phase flow region, however, reaches its maximum when the water flux approaches zero at hydrostatic conditions.
10 July 2015 in Soil Science Society of America Journal
29 July 2023 in Agricultural Water Management
28 August 2020 in Water Resources Research
The use of treated wastewater (WW) for irrigation is steadily increasing worldwide. However, irrigation with WW requires special attention as it may alter soil hydraulic properties and, eventually, affect crop yields. The main goal of this study was to investigate two approaches that could mitigate this adverse impact: (i) mixing WW with local freshwater (FW) and (ii) adjusting the irrigation management and design to the deteriorated soil hydraulic properties. Four water qualities resulting from mixing FW and WW at different ratios for irrigation of an avocado orchard planted on a clayey soil were considered: FW, M1/3 (2/3 FW – 1/3 WW), M2/3 (1/3 FW ‐ 2/3 WW), and WW. Increasing the WW component in the irrigation water reduces the soil's saturated hydraulic conductivity and infiltrability, and this reduction is depth dependent. It also reduces the transpiration of trees and their trunk growth. This is supported by numerical simulations that showed that irrigation with WW produced the reduction in plant transpiration relative to irrigation with FW. Numerical simulations indicated that irrigation management and design could be adjusted to improve plant water uptake and reduce the differences due to water quality. The results indicate that decreasing the irrigation rate and increasing the wetted area per tree could increase the water uptake in WW‐irrigated soils to almost equal that in FW‐irrigated soils. This can be achieved by using drippers with lower discharge and by using more drippers per dripline, more driplines per tree, and more drippers per tree (concentric loops of driplines around each trunk).
21 October 2015 in Water Resources Research
Colloid filtration theory (CFT) is a conceptual construct for predicting the characteristic rate of colloid‐surface collisions during transport in granular porous media. A central product of this theory is the correlation equation for predicting collection‐efficiency (η), based exclusively on theoretical model development. Specifically, the η‐equation has terms combining dimensionless groups (of physicochemical properties) with unknown parameters that are usually fitted so that the predicted η matches that determined by colloid‐surface collisions simulated in idealized pore‐scale models. In this study, we replace the simulated colloid‐surface collisions in idealized models with experimental column‐scale data on apparent colloid‐surface collisions. A new correlation equation is obtained by minimizing the difference between η determined by the correlation equation and that determined experimentally, using data from a collection of experiments for favorable conditions for colloid filtration. In this way, we parameterize a mechanistically based η‐equation with empirical evidence. The impact of different properties of colloids and porous media is studied by comparing experimental properties with different terms of the correlation equation. This comparison enables insight about the different processes that occur during colloid transport and retention in porous media, such as diffusion and interception, and provides directions for future CFT developments that will need to account for these processes differently than the current theory does. Additionally, we find that while most of the parameters of the presented η‐equation are only slightly different than those proposed in previous theoretical studies, the match between theory and observation is significantly improved. For the available experimental data, which provide a reasonable representation of property ranges for many applications of CFT, the proposed equation provides a closer match to the experimentally measured collection efficiencies compared to available theories to date.
1 March 2024 in Physiologia Plantarum
In plant tissue culture, callus formation serves as a crucial mechanism for regenerating entire plants, enabling the differentiation of diverse tissues. Researchers have extensively studied the influence of media composition, particularly plant growth regulators, on callus behavior. However, the impact of the physical properties of the media, a well‐established factor in mammalian cell studies, has received limited attention in the context of plant tissue culture. Previous research has highlighted the significance of gelling agents in affecting callus growth and differentiation, with Agar, Phytagel, and Gelrite being the most used options. Despite their widespread use, a comprehensive comparison of their physical properties and their subsequent effects on callus behavior remains lacking. Our study provides insights into optimizing plant tissue culture media by analyzing the physical properties of gelling agents and their impact on callus induction and differentiation. We compared the phenotypes of calli grown on media composed of these different gelling agents and correlated them to the physical properties of these media. We tested water retention, examined pore size using cryo‐SEM, measured the media mechanical properties, and studied diffusion characteristics. We found that the mechanical properties of the media are the only quality correlated with callus phenotype.