11 December 2024 in International Journal for Numerical and Analytical Methods in Geomechanics
6 November 2023 in Engineering Computations
Purpose: The purpose of this paper is to simulate the tension process of tension-type anchor cable and to explore the mechanical characteristics and tension-torsion coupling effect of anchor cable subjected to tension.Design/methodology/approach: ABAQUS numerical software is applied to construct the numerical models of tension-type anchor cables with different diameters. Through explicit contact, the characteristics of contact between grouting body-anchor cable and grouting body-rock mass are determined. Confining pressure is applied to the model through surface pressure, and drawing force is applied to the model by displacement loading so as to simulate the tension process of the anchor cable.Findings: The results show that the stress is transmitted in both axial and radial directions in the anchorage section and distributed in a cone. The shear stress in the grouting body is unevenly distributed, and its peak value increases with the rise in confining pressure and anchor cable diameter. The stress characteristics of torque and axial force are basically consistent and evenly distributed in the free section; they gradually decrease in the anchorage section. Due to the tension-torsion coupling effect, the internal stress characteristics of the anchor cable structure vary. On average, the anchorage performance of each anchor cable model is improved by 6.19%.Originality/value: The proposed method of numerical modelling is effective in addressing the interface contact between the anchor cable and the grouting body and in solving the problem with convergence of calculation. Compared with the indoor test, this method is more suited to collecting the internal mechanical data of the anchor body.
5 August 2025 in Engineering Computations
Purpose: The purpose of this paper is to simulate the tension process of pressure-type anchor cables and to explore the damage characteristics and mechanical properties within the anchorage section under different bearing plate sizes and joint angles. Design/methodology/approach: The numerical model of the anchoring section of the pressure-type anchor cable was established using the ABAQUS numerical simulation software. Contact properties between the anchor cable-grout interface and grout-surrounding rock interface were precisely defined. The tensioning process was simulated by applying displacement loads to the anchor cable, followed by computational analysis of the numerical model. Findings: Under load, the grouting body undergoes compressive damage. When the axial force of the anchor cable reaches 227.1 kN, the internal stress distribution of the grout becomes more uniform, limiting the expansion of the damaged zone. When the ratio of the cross-sectional area of the bearing plate to the grouting body increases from 0.179 to 0.318 to 0.498, the peak axial force increases by 33.2 and 22.5%, enhancing cable capacity. Joints significantly influence shear stress distribution, with peak shear stress 60% higher at the upper joint-surrounding rock interface than near the bearing plate. Research limitations/implications: The research provides an effective numerical approach for stress analysis and design optimization of anchorage systems, though limited by lack of experimental validation and simplified interface contact assumptions, suggesting future experimental verification for improved model accuracy. Practical implications: The numerical simulation method proposed in this paper effectively addresses the challenge of obtaining internal stress distribution and damage characteristics of pressure-type anchor cables through physical model tests. It provides a more accurate and detailed analysis of the stress distribution and load transfer mechanisms within the anchorage section. Social implications: Numerical simulation provides an in-depth exploration of the internal damage characteristics and mechanical properties of the anchored section of pressure-type anchor cables, which can be used as a reference for relevant theoretical studies, scientific experiments and engineering practice. Originality/value: In this paper, based on the three-dimensional finite element model established by ABAQUS, the contact property problem of the interface between the grouting body and the surrounding rock is solved, which can explore the internal damage characteristics of the pressure-type anchor cable anchored section and its mechanical properties and provide a reference for future numerical simulation studies of tension-dispersed and pressure-dispersed types.
3 April 2024 in International Journal for Numerical and Analytical Methods in Geomechanics