Corrado Garlisi

Corrado Garlisi

Auto-generated profile, based on publicly available information

Corrado Garlisi

Luxembourg Institute of Science and Technology, Luxembourg

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 March 2023 in Chemical Engineering Science
Verified
Journal Article
Closed access
AYAhmed Yusuf
Ahmed Yusuf
CGCorrado Garlisi
Corrado Garlisi
RMRodrigo Peralta Muniz Moreira
Rodrigo Peralta Muniz Moreira
Gianluca Li PumaGianluca Li Puma
Gianluca Li Puma
GPGiovanni Palmisano
Giovanni Palmisano

15 January 2022
Verified
Book Chapter
Closed access
Giovanni PalmisanoGiovanni Palmisano
Giovanni Palmisano
SJSamar Al Jitan
Samar Al Jitan
CGCorrado Garlisi
Corrado Garlisi

29 July 2021 in Journal of Photocatalysis
Verified
Journal Article
Open access
PDF file
CGCorrado Garlisi
Corrado Garlisi
AYAhmed Yusuf
Ahmed Yusuf
Giovanni PalmisanoGiovanni Palmisano
Giovanni Palmisano
Background: Microreactor devices have attracted increasing attention over the last years due to their high surface-to-volume ratio, which ensures a high heat and mass transfer, short molecular diffusion distance and greater spatial illumination homogeneity compared to the traditional reactors. Objective: The aim of this study was to model the kinetics of photo-degradation of 2-propanol over TiO2-based thin films in a gas-phase batch-reactor and simulate their performance in a microreactor device. Methods: The reaction was carried out in a gas-phase batch-reactor, assessing the reactivity of singlelayer nitrogen (N)-doped TiO2 and a bilayer consisting of N-doped TiO2 as a bottom layer and copper (Cu)-doped TiO2 as a top layer. The kinetics of the photocatalytic process was modelled by Langmuir– Hinshelwood (LH) model. The constants obtained from the LH model were used to simulate the performance of the photocatalysts in a microreactor, operating in a continuous flow mode and investigating the effect of the volumetric flow rate (Q), initial concentration of pollutant (Co), number of microchannels (n) and microchannel length (l) on the photo-degradation of 2-propanol. Results: N-Cu-TiO2 exhibited a higher reactivity but a lower adsorption ability towards the target pollutant compared to N-TiO2. To maximize and leverage the advantages of a microreactor, optimal operating conditions for a continuous flow mode, at a steady-state, should be moderately low Q and Co, long l and n that minimizes flow maldistribution in parallel. Conclusion: The findings in this work could serve as a basis to design and fabricate efficient microreactors for the removal of VOC in air purification applications.