This paper presents the state of the art of self-etch adhesive systems. Four topics are shown in this review and included: the historic of this category of bonding agents, bonding mechanism, characteristics/properties and the formation of acid-base resistant zone at enamel/dentin-adhesive interfaces. Also, advantages regarding etch-and-rinse systems and classifications of self-etch adhesive systems according to the number of steps and acidity are addressed. Finally, issues like the potential durability and clinical importance are discussed. Self-etch adhesive systems are promising materials because they are easy to use, bond chemically to tooth structure and maintain the dentin hydroxyapatite, which is important for the durability of the bonding.
SUMMARY: Objectives: The aims of this study were to characterize inorganic content (IC), light transmission (LT), biaxial flexural strength (BFS), and flexural modulus (FM) of one conventional (layered) and four bulk-fill composites at different depths. Methods: Bulk-fill composites tested were Surefil SDR flow (SDR), Filtek Bulk Fill (FBF), Tetric EvoCeram Bulk Fill (TEC), and EverX Posterior (EXP). Herculite Classic (HER) was used as a control. Energy dispersive x-ray analysis and scanning electron microscopy were used to characterize filler particle composition and morphology. The LT through different composite thicknesses (1, 2, 3, and 4 mm) was measured using a laboratory-grade spectral radiometer system (n=5). For the BFS and FM tests, sets of eight stacked composite discs (0.5-mm thick) were prepared simulating bulk filling of a 4-mm-thick increment (n=8). Results: SDR demonstrated larger, irregular particles than those observed in TEC or HER. Filler particles in FBF were spherical, while those in EXP were composed of fiberglass strands. The LT decreased with increased composite thickness for all materials. Bulk-fill composites allowed higher LT than the HER. Furthermore, HER proved to be the unique material, having lower BFS values at deeper regions. SDR, FBF, and TEC bulk-fill composites presented reduced FM with increasing composite depth. Conclusions: The bulk-fill composites investigated exhibited higher LT, independent of different filler content and characteristics. Although an increase in composite thickness reduced LT, the BFS of bulk-fill composites at deeper layers was not compromised.
1 October 2020 in Journal of the Mechanical Behavior of Biomedical Materials
Protecting resin-dentin interfaces from hydrolytic and enzymatic degradation is critical for the longevity of adhesive restorations. In recent years, several strategies have been tested in vitro to induce apatite precipitation within interfibrillar and intrafibrillar collagen spaces, as well as in resin-sparse regions where the adhesive infiltration was incomplete. Also, the presence of calcium ions and other metallic ions has shown an inhibitory effect on enzymatic activity. Ion-releasing particles and biomimetic analogs have been studied for hybrid layer remineralization. Overall, remineralization strategy is dependent on the remaining mineral content. In partially demineralized dentin, residual apatite crystallites serve as nucleation sites for calcium and phosphate ions precipitation and crystal growth (“top-down” remineralization). In completely demineralized dentin where crystallites are absent (e.g., acid etched dentin) the use of mineral nano-precursors assisted by non-collagenous proteins analogs are necessary (“bottom-up” remineralization). This article reviews the approaches for hybrid layer remineralization and resin-dentin interface preservation.
29 June 2020 in Journal of Esthetic and Restorative Dentistry