The diffusion of all stable lanthanides was measured both in calcia stabilized zirconia (CSZ) and in yttria stabilized zirconia (YSZ) in the temperature range between 1286 and 1600 °C. The lanthanide diffusion coefficients obtained increase with increasing ionic radius. The experimental activation enthalpy of diffusion is near 6 eV for CSZ and between 4 and 5 eV for YSZ and is not strongly affected by the type of lanthanide. The results were correlated with defect energy calculations of the lanthanide diffusion enthalpy using the Mott-Littleton approach. An association enthalpy of cation vacancies with oxygen vacancies of about 1 eV (96 kJ/mol) was deduced in the case of CSZ, while there is no association in the case of YSZ. Furthermore, the change in diffusion coefficients can be correlated to the interaction parameter for the interaction between the lanthanide oxide with zirconia: The higher the interaction parameter, the higher the lanthanide diffusion coefficient.
"Montmorillonite (MMT) clays are 2:1 layered structures which in natural state may allocate different hydrated cations such as M-nH2O (M= Na, Ca, Fe, etc.) in its interlayer space. Depending on the capability for ion sorption, these materials are interesting for environmental remediation. In this work we experimentally study the Co sorption in a natural Na-MMT using UV-visible spectrometry and XRD on semi-oriented samples, and then analyze the sorption ability of this clay by means of ab initio calculation performed on pristine MMT. The structural properties of Na-MMT and Co-adsorbed MMT, and the hyperfine parameters at different atomic sites were analyzed and compared with the experimental ones for the first clay. For the case of the Co-MMT, the hyperfine parameters are presented for the first time. The theoretical predictions based on total energy considerations confirm that Co incorporation replacing Na is energetically favorable. Also, the basal spacing d001 experimentally obtained is well reproduced by the ab initio calculation."
The electric field gradient (EFG) at the highly dilute nuclear probe Cd in the heavy fermion systems CeIn, Co, Rh, and Ir and YCoIn has been investigated by perturbed angular correlation (PAC) measurements of the nuclear electric quadrupole interaction (QI) of Cd on In sites. Pure and Sn-doped single crystals prepared by In-flux synthesis and polycrystalline samples prepared by arc melting have been studied. The samples were doped with the PAC probe Cd by diffusion of the mother isotope In. In all samples, several fractions of Cd probe nuclei subject to different QI's have been observed, among them a large fraction of Cd in unreacted In metal. Detailed calculations of the EFG at In nuclei and at Cd probes on In sites of pure and Sn-doped CeIn were preformed, using the full-potential augmented plane wave+local orbital (APW+lo) formalism and taking into account different variables such as the electronic structure of the hyperfine probes, probe induced structural distortions, and impurity doping. The excellent agreement between the predicted EFG's and the experimental results allows us to assign two of the observed EFG components to the lattice sites 1 and 4 of the CeIn compounds and to explain the pronounced difference of the EFG at In and Cd probes on the same lattice position. Structural distortions induced by the Cd probe and Sn-doping were found to have little effect on the EFG at the Cd probes. We also show that the local spin density approximation (LSDA) and LDA+ calculations predict very similar equilibrium structures and EFG's at the In/Cd sites. The extension of the experiments and the calculations from CeIn to YCoIn and LaCoIn have established that the influence of the 4 electrons on the EFG's at impurity sites is negligibly small.
1 November 2019 in Journal of Environmental Radioactivity