In a multi-state manufacturing system, preventive maintenance is performed on other machines once the performance of a machine falls below a threshold state. Many investigations have been performed on the maintenance of manufacturing systems. However, studies on preventive maintenance for manufacturing systems that account for the different costs involved are limited. This paper focuses on the analysis of multi-state machines in a manufacturing system considering different costs. Subsequently, a cost-based preventive maintenance prioritisation method for multi-state machines is proposed. Based on the buffer capacity, three maintenance policies on the machines are discussed. Different machine failures lead to different maintenance priorities. The real-time buffer capacity greatly influences the selection of machines for preventive maintenance. The set of the optimal machines for preventive maintenance is determined based on the constraints of machine running time and different preventive maintenance costs. Finally, a numerical example is used to demonstrate the effectiveness of the proposed method.
16 November 2022 in International Journal of Production Research
The development of society has put forward higher requirements for the supply of maintenance spare parts. However, the current support index is not comprehensive enough to evaluate the system ability. Meanwhile, the influence of horizontal supply time on spare parts storage is not fully reflected. Therefore, the problem of spare parts storage configuration in two-echelon maintenance and supply support systems is analysed in the paper. First, the state transition rates of different parts are studied under the context. Then a system-level comprehensive support rate based on importance measure is proposed. To determine the number of different spare parts, an optimisation model is established to maximise system support efficiency. Furthermore, a site importance measure based on horizontal supply time is proposed to measure the site priority over spare parts storage. Next, a two-stage decision method is presented for determining the location of spare parts. Finally, the feasibility of the proposed method is verified with the help of an example for the aircraft maintenance and supply support system.
The reliability of the transportation network is studied by simulating the attack on the important edges. The important edges are deliberately attacked, and the impedance of the attacking edges is set to infinity. Then the influence of the characteristics of single failure edge on network reliability change and the influence of failure edge number on network reliability change are studied. Two test schemes are designed to compare the changes of network reliability in three failure experiments. At last, for the transportation network ofZhengzhou-Europe International Block train, the simulation experiment of the transportation network reliability is curried out to demonstrate the proposed method. The reliability of the transportation network is studied through numerical simulation, which is helpful to improve the reliability of the transportation network and reduce the huge economic loss caused by the failure.