The optimization of graphene growth on copper foils using an atmospheric pressure chemical vapor deposition setup is reported. CH4 and H2 were used as precursor gases and Raman spectroscopy as the main graphene characterization technique. Different growth parameters, including temperature and reaction time, the molar ratio of CH4/H2 in the feed and total flow of gases during the reaction step, were studied in detail. It was shown that graphene growth was not homogeneous in the entire sample, multilayer graphene was present in most of the sample, however as the synthesis parameters were optimized, graphene gained better quality, obtaining bilayer graphene over most of the sheet in the final optimized sample. Homemade software was used to analyze the quality of the synthesised graphene, obtaining a more quality graphene according to the synthesis parameters optimized. An optimal bilayer graphene sample was prepared at the lowest growth time (10 min) and the highest synthesis temperature (1050 °C), using a CH4/H2 flow ratio and a total flow rate ratio of precursors of 7% and 60 Nml (CH4 + H4) per min respectively.
The optimization of the graphene growth over polycrystalline nickel foils using an atmospheric pressure Chemical Vapor Deposition set-up is reported. CH4 and H2 were used as precursor gases. Optical microscopy and Raman spectroscopy were used for graphene characterization. A thickness value related to the number of graphene layers in the synthesized samples was quantified using an Excel-VBA application, which assigned a thickness value between 0 and 1000 and allowed one to know the percentage of each type of graphene (monolayer, bilayer, multilayer) deposited over the Ni foil. The influence of reaction temperature, CH4/H2 flow rate ratio and reaction time was studied in detail. Optical microscopy showed that the samples were not homogeneous, being covered with multilayer, few-layer, bilayer and monolayer graphene. Synthesis variables were optimized according to the thickness value. There was observed a maximum thickness value (781) for 980 °C, a CH4/H2 flow rate ratio of 0.07 v/v and a reaction time of 60 seconds. At these conditions, about 77% of the Ni foil was covered with monolayer graphene.