Rolando Burgos
Auto-generated profile, based on publicly available information

Rolando Burgos

Center for Power Electronics Systems (CPES), Virginia Tech, Blacksburg, VA, USA

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 January 2015 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
BWBo Wen
Bo Wen
DBDushan Boroyevich
Dushan Boroyevich
RBRolando Burgos
Rolando Burgos
PMPaolo Mattavelli
Paolo Mattavelli
ZSZhiyu Shen
Zhiyu Shen
This paper analyzes the small-signal impedance of three-phase grid-tied inverters with feedback control and phase-locked loop (PLL) in the synchronous reference (d-q) frame. The result unveils an interesting and important feature of three-phase grid-tied inverters - namely, that its q-q channel impedance behaves as a negative incremental resistor. Moreover, this paper shows that this behavior is a consequence of grid synchronization, where the bandwidth of the PLL determines the frequency range of the resistor behavior, and the power rating of the inverter determines the magnitude of the resistor. Advanced PLL, current, and power control strategies do not change this feature. An example shows that under weak grid conditions, a change of the PLL bandwidth could lead the inverter system to unstable conditions as a result of this behavior. Harmonic resonance and instability issues can be analyzed using the proposed impedance model. Simulation and experimental measurements verify the analysis.

16 August 2013 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
XSXu She
Xu She
AHAlex Q. Huang
Alex Q. Huang
RBRolando Burgos
Rolando Burgos
The solid-state transformer (SST), which has been regarded as one of the 10 most emerging technologies by Massachusetts Institute of Technology (MIT) Technology Review in 2010, has gained increasing importance in the future power distribution system. This paper presents a systematical technology review essential for the development and application of SST in the distribution system. The state-of-the-art technologies of four critical areas are reviewed, including high-voltage power devices, high-power and high-frequency transformers, ac/ac converter topologies, and applications of SST in the distribution system. In addition, future research directions are presented. It is concluded that the SST is an emerging technology for the future distribution system.

3 April 2015 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
BWBo Wen
Bo Wen
DDDong Dong
Dong Dong
DBDushan Boroyevich
Dushan Boroyevich
RBRolando Burgos
Rolando Burgos
PMPaolo Mattavelli
Paolo Mattavelli
ZSZhiyu Shen
Zhiyu Shen
Grid synchronization stability issues and subsynchronous oscillations between synchronous generators exist in electrical power systems. Three-phase voltage-source converters (VSCs) are being installed more and more in the grid to improve efficiency or to utilize renewable energy sources. The same stability issues between VSCs are also reported and analyzed using a small-signal model of phase-locked loops (PLLs). This paper proposes a different impedance-based analysis method. The proposed method shows that synchronization instability in a VSC system is due to the negative incremental resistance behavior of grid-tied inverters' impedance when they are modeled in the d-q frame. System can be stabilized simply by changing the inverter's PLL design. Experimental results verify the analysis and the proposed method.

1 May 2011 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
RWRuxi Wang
Ruxi Wang
FWFei Wang
Fei Wang
DBD. Boroyevich
D. Boroyevich
RBR. Burgos
R. Burgos
RLRixin Lai
Rixin Lai
KRK. Rajashekara
K. Rajashekara
It is well known that single-phase pulse width modulation rectifiers have second-order harmonic currents and corresponding ripple voltages on the dc bus. The low-frequency harmonic current is normally filtered using a bulk capacitor in the bus, which results in low power density. However, pursuing high power density in converter design is a very important goal in the aerospace applications. This paper studies methods for reducing the energy storage capacitor for single-phase rectifiers. The minimum ripple energy storage requirement is derived independently of a specific topology. Based on the minimum ripple energy requirement, the feasibility of the active capacitor's reduction schemes is verified. Then, we propose a bidirectional buck-boost converter as the ripple energy storage circuit, which can effectively reduce the energy storage capacitance. The analysis and design are validated by simulation and experimental results.

1 May 2010
Verified
Conference Paper
Closed access
DBDushan Boroyevich
Dushan Boroyevich
ICIgor Cvetkovic
Igor Cvetkovic
DDDong Dong
Dong Dong
RBRolando Burgos
Rolando Burgos
FWFei Wang
Fei Wang
FLFred Lee
Fred Lee
Although it has long been argued that electronic power converters can help improve system controllability, reliability, size, and efficiency, their penetration in power systems is still quite low. The often-cited barriers of higher cost and lower reliability of the power converters are quite high if power electronics is used as direct, one-to-one, replacement for the existing electromechanical equipment. However, if the whole power distribution system were designed as a system of controllable converters, the overall system cost and reliability could actually improve, as is currently the case at low power levels within computer and telecom equipment. Starting from the example of a computer power system, the paper contemplates possible future ac and dc electronic power distribution system architectures, especially in the presence of renewable energy sources. The proposed nanogrid-microgrid-...-grid structure achieves hierarchical dynamic decoupling of generation, distribution, and consumption by using bidirectional converters as energy control centers. This is illustrated by the description and simulation of static and dynamic operation of a dc nanogrid in a hypothetical future sustainable home. Several ideas for modeling, analysis, and system-level design of such systems, including power flow control, protection, stability, and subsystem interactions, are presented.

4 December 2014 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
BWBo Wen
Bo Wen
DBDushan Boroyevich
Dushan Boroyevich
RBRolando Burgos
Rolando Burgos
PMPaolo Mattavelli
Paolo Mattavelli
ZSZhiyu Shen
Zhiyu Shen
Small-signal stability is of great concern for electrical power systems with a large number of regulated power converters. In the case of dc systems, stability can be predicted by examining the locus described by the ratio of the source and load impedances in the complex plane per the Nyquist stability criterion. For balanced three-phase ac systems the same impedance-based method applies, for which this paper uses impedances in the synchronous rotating reference (d-q) frame. Small-signal stability can be determined by applying the generalized Nyquist stability criterion (GNC). This approach relies on the actual measurement of these impedances, which up to now has severely hindered its applicability. Addressing this shortcoming, this paper investigates the small-signal stability of a three-phase ac system using measured d-q frame impedances. The results obtained show how the stability at the ac interface can be easily and readily predicted using the measured impedances and the GNC, thus illustrating the practicality of the approach, and validating the use of ac impedances as a valuable dynamic analysis tool for ac system integration, in perfect dualism with the dc case.