23 August 2014 in Chinese Journal of Mechanical Engineering
The identification of maximum road friction coefficient and optimal slip ratio is crucial to vehicle dynamics and control. However, it is always not easy to identify the maximum road friction coefficient with high robustness and good adaptability to various vehicle operating conditions. The existing investigations on robust identification of maximum road friction coefficient are unsatisfactory. In this paper, an identification approach based on road type recognition is proposed for the robust identification of maximum road friction coefficient and optimal slip ratio. The instantaneous road friction coefficient is estimated through the recursive least square with a forgetting factor method based on the single wheel model, and the estimated road friction coefficient and slip ratio are grouped in a set of samples in a small time interval before the current time, which are updated with time progressing. The current road type is recognized by comparing the samples of the estimated road friction coefficient with the standard road friction coefficient of each typical road, and the minimum statistical error is used as the recognition principle to improve identification robustness. Once the road type is recognized, the maximum road friction coefficient and optimal slip ratio are determined. The numerical simulation tests are conducted on two typical road friction conditions(single-friction and joint-friction) by using CarSim software. The test results show that there is little identification error between the identified maximum road friction coefficient and the pre-set value in CarSim. The proposed identification method has good robustness performance to external disturbances and good adaptability to various vehicle operating conditions and road variations, and the identification results can be used for the adjustment of vehicle active safety control strategies.
1 December 2014 in Journal of Terramechanics
4 April 2024 in IEEE Transactions on Vehicular Technology
This paper proposes a novel LiDAR inertial odometry (LIO) incorporating vehicle motion characteristics (VMC) tailored for ground vehicles. While most advanced LIO systems are designed for 6 degrees of freedom (DOF) SE(3), which are not ideally suited for ground vehicles, this paper investigates the performance of the vehicle-LiDAR-IMU system by considering the vehicle motion characteristics. The system combines IMU propagation, LiDAR measurements, ground surface measurements and 3 dimension (3D) vehicle kinematic model measurements within an iterated Kalman filter framework. To ensure a robust system bootstrapping, the temporal and spatial parameters of the vehicle-LiDAR-IMU system are calibrated first. Then, in addition to the IMU preintegration and LiDAR measurements, constraints are established between the ground surface and the vehicle pose by calculating the normal of the ground beneath the vehicle in the local point cloud map. Moreover, measurements of the 3D vehicle kinematic model with angular velocity and velocity constraints are adopted. Ground surface is considered in the 3D kinematic model for vehicle angular velocity calculation. The results from simulations and vehicle experiments demonstrate that the proposed method improves accuracy compared with state-of-the-art LiDAR SLAM methods while maintaining a real-time implementation capability for vehicles.
30 August 2015 in Chinese Journal of Mechanical Engineering
9 January 2024 in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
The instantaneous vehicle turn center is of great significance in the design and analysis of vehicle steering and handling. Due to the influences of vehicle flexible components, the vehicle turn center is not intersected at one point and the traditional determination method for vehicle turn center is not applicable for multi-axle vehicles. In this paper, a novel instantaneous tire turn center (TTC) method is proposed to estimate the instantaneous vehicle turn center to provide a guidance for the design of vehicle steering and analysis of handling. The motivation of the tire turn center concept is introduced and the calculation method is developed. The instantaneous vehicle turn center is estimated based on the calculation of instantaneous TTC. The estimation results of the vehicle turn center of a two-axle vehicle and a three-axle off-road vehicle under different vehicle velocities and lateral accelerations during steering are presented based on the vehicle dynamics models built by ADAMS software. Since there is no simplifications of the vehicle in the proposed estimation method, the determined instantaneous vehicle turn center is more accurate and can reflect the actual vehicle motion better as compared to the traditional vehicle turn center in transient motion process. The estimated instantaneous vehicle turn center provides a guidance for design and optimization of vehicle steering as well as steering angles control strategies to make all tire turn centers controlled at the instantaneous vehicle turn center, thus reducing tire wears and improving the whole vehicle steering coordination performance.