16 October 2024 in The Plant Phenome Journal
Unmanned aerial vehicle (UAV)‐acquired multispectral images commonly suffer from radiometric inaccuracies due to changing illumination produced by intermittent cloud cover. This study addressed cloud shadow effects by integrating direct irradiance measurements from a downwelling light sensor into reflectance calculations. Two reflectance calibration methods were proposed as follows: (1) use of a single calibration reference panel for all images (Method 1) and (2) employment of a minimum distance classifier to assign color‐graded in‐field reflectance calibration targets to individual images based on their proximity in irradiance levels (Method 2). Images were acquired from 30 and 75 m flight altitudes with fixed‐exposure and auto‐exposure settings. Conventional photogrammetric calibration of UAV multispectral images inadequately addressed cloud shadows, resulting in orthomosaics with poor to moderate spatial uniformity (R2 = 0.70–0.92) and high mean absolute percentage error (MAPE = 13.52%–49.18%). The proposed calibration methods improved radiometric accuracy, yielding average R2 = 0.99 and 0.98 at 30 and 75 m images, respectively. Method 1 showed superior performance on the red‐edge and near infrared bands, and Method 2 worked best in the blue, green, and red bands. Post‐processing empirical line calibration of orthomosaics from Methods 1 and 2 reduced MAPE in reflectance estimation by at least 50% compared to conventional calibration. The clear sky reference histograms had lower Jensen–Shannon distance, higher Pearson's correlation, and improved intersection ratios with the histograms from the proposed methods, implying high similarity. Vegetation indices calculated with the proposed methods closely matched those from the reference orthomosaic, exhibiting significantly lower MAPE than conventionally calculated vegetation indices.
8 August 2023 in Environmental Research
1 January 2012 in Applied Engineering in Agriculture
12 May 2014 in Transactions of the ASABE
Electricity is a major cost for cotton gins, representing approximately 20% of variable costs. Fans used for pneumatic conveying consume the majority of electricity at cotton gins. Development of control systems to reduce the air velocity used for conveying seed cotton could significantly decrease electricity use and cost. A greater understanding of the pneumatic conveying characteristics of seed cotton is necessary for development of these systems. A negative pressure conveying system was constructed with a feed control, conveying pipe, separator, and fan. Air velocity was measured at the system inlet and in the conveying section when testing with air only. A differential pressure measurement was taken in the conveying pipe, and temperature and relative humidity were recorded. Two pipe diameters, two cultivars, two moisture content levels, and three seed cotton feed rates were included in the experimental design. Seed cotton was fed into the conveying system, and the fan speed was decreased until choking occurred. The minimum differential pressure measurement indicated the saltation velocity. A segmented linear model was fit to the log transformed data to identify the mass flow ratio and Froude number (Fr) corresponding to the minimum pressure. This model accurately fit the data (R2 = 0.88) and resulted in the following equation for finding the saltation velocity: ϕ = 8.90 × 10-5 × Frmin5.04, where Frmin is the Fr at the saltation velocity. The solids resistance factor at velocities greater than saltation was found to be 0.179 × Fr-1. This model had an R2 of 0.91 and predicted the pressure drop with 14.2% error. Pipe diameter, cultivar, and moisture content level did not have a practically significant effect on the models developed to predict saltation velocity or the solids resistance factor. These models may be useful in designing control systems for cotton gin conveying systems, resulting in significant electricity and cost savings.