Stable water-in-crude-oil emulsions remain a bottleneck in the treatment of heavy Uzbek crudes, and the demulsifiers used at field level are almost entirely imported. Two local secondary streams—the xylene-rich Ustyurt pyrolysis distillate and collected waste motor oil—were converted into a multicomponent demulsifier. Xylene was sulfonated with 98 wt.% H2SO4 and neutralised to sodium xylenesulfonate (SXS), reaching 96.8% isolated yield at 110–120 °C and an acid:xylene molar ratio of 1.34:1. Fixed-time yields gave a linear Arrhenius dependence (R2 = 0.998) with an apparent activation energy of 21.7 kJ mol−1, ΔH‡ = 18.4 kJ mol−1 and ΔS‡ = −262 J mol−1 K−1, indicating a transport-influenced electrophilic substitution. FTIR confirmed the –SO3Na group, and TG/DTA showed only 5.9% mass loss below 415 °C. Of four hydrophilic–lipophilic balance estimates, only the Davies value (14.2) is compatible with the observed water solubility. The optimum formulation KS-6 (30 wt.% SXS, 50 wt.% waste oil, 18 wt.% Ca and 2 wt.% Sr stearate) gave water-separation efficiencies of 81.0, 93.7 and 98.9% at water cuts of 60, 70 and 80 vol.%, exceeding the imported reference ND-12 by factors of 1.18–1.26, and lowered the residual salt content to 125 mg dm−3.
Guanidine thiocyanate (GT), a solid by-product of guanidine-salt manufacture, combines a valuable antimicrobial guanidinium cation with a toxic, oxidation-sensitive thiocyanate anion. Here, both ions are converted into useful products. In stage I, aqueous GT is treated with CuCl2 and metallic copper at 20–30 °C; Cu2+/Cu0 synproportionation (ΔE° = +1.14 V) precipitates β-CuSCN in 92 % yield without thiocyanate oxidation or acid formation, leaving guanidinium chloride (GuCl) in solution. In stage II, GuCl reacts with acrylic acid; speciation analysis (K ≈ 7•10−11) and FTIR show that the product is a mixture of guanidinium salts and partially polymerised acrylic acid rather than guanidinium acrylate. In a formalin-modified poly(vinyl alcohol) (PVA)/silica sol adhesive, the modifier shifts the ζ-potential of silica from −28.6 to +2.5 mV; at the resulting ionic strength (≈0.26 mol kg−1) DLVO theory predicts no electrostatic barrier, so the 120-day stability is attributed to steric stabilisation by adsorbed PVA. Compared with an unmodified PVAc reference, the adhesive shows 44–62 % higher lap-shear strength (5.2–6.8 MPa), lower 24 h water uptake (1.8 vs. 7.6 %) and antibacterial activity that is 91.8 % retained after washing, at a net raw-material cost of ≈2.1 kUSD t−1.