1 November 2011 in Applied Surface Science
27 May 2025 in Geochimica et Cosmochimica Acta
1 November 2020 in IOP Conference Series: Materials Science and Engineering
Application of protective coatings is the most widely used conservation treatment for outdoor bronzes. Eco-friendly and non-hazardous coatings are currently needed for conservation of outdoor bronze monuments. To fulfil this need, the M-ERA.NET European research project B-IMPACT (Bronze-IMproved non-hazardous PAtina CoaTings) aimed at assessing the protectiveness of innovative coatings for historical and modern bronze monuments exposed outdoors. In this project, two bronze substrates (historical Cu-Sn-Zn-Pb and modern Cu-Si-Mn alloys) were artificially patinated, by acid rain solution using dropping test and by “liver of sulphur” procedure (K2S aqueous solution) to obtain black patina, respectively. Subsequently, the application of several newly developed protective coatings was carried out and their performance was investigated by preliminary electrochemical tests. In the following steps of the work, the assessment of the best-performing coatings was carried out and their performance was compared to Incralac, one of the most widely used protective coatings in conservation practice. A multi-analytical approach was adopted, considering artificial ageing (carried out in representative conditions, including exposure to rain runoff, stagnant rain and UV radiation) and metal release, as well as visual aspect (so as to include aesthetical impact among the coating selection parameters) and morphological and structural evolution of the coated surfaces due to simulated outdoor exposure. Lastly, also the health impact of selected coatings was assessed by occupational hazard tests. The removability and re-applicability of the best-performing coatings were also assessed. The best alternatives to the conventional Incralac exhibited were: (i) fluoroacrylate blended with methacryloxy-propyl-trimethoxy-silane (FA-MS) applied on patinated Cu-Sn-Zn-Pb bronze and (ii) 3-mercapto-propyl-trimethoxysilane (PropS-SH) applied on patinated Cu-Si-Mn bronze.
12 April 2024 in Journal of Vacuum Science & Technology A
Deposition of silica-based thin films on carbon microfibers has long been considered a challenge. Indeed, the oxidation-sensitive nature of carbon microfibers over 550 K and their submicron-textured surface does not bode well with the required conformity of deposition best obtained by atomic layer deposition (ALD) and the thermal oxidative conditions associated with common protocols of silica ALD. Nonetheless, the use of a catalytic ALD process allowed for the deposition of amorphous alumina–silica bilayers from 445 K using trimethylaluminium and tris(tert-pentoxy)silanol (TPS). In this study, first undertaken on flat silicon wafers to make use of optical spectroscopies, the interplay between kinetics leading to a dense silica film growth was investigated in relation to the applied operation parameters. A threshold between the film catalyzed growth and the complete outgassing of pentoxy-derived compounds from TPS was found, resulting in a deposition of equivalent growth per cycle of 1.1 nm c−1, at a common ALD rate of 0.3 nm min−1, with a flat thickness gradient. The deposition on carbon microfiber fabrics was found conformal, albeit with a thickness growth capped below 20 nm, imparted by the microfiber surface texture. STEM-EDX showed a sharp interface of the bilayer with limited carbon diffusion. The conformal and dense deposition of alumina–silica thin films on carbon microfibers holds great potential for further use as refractory oxygen barrier layers.
17 October 2023 in ACS Applied Engineering Materials
5 November 2025 in Applied Surface Science