1 June 2015 in Journal of Petroleum Science and Engineering
6 April 2015 in Industrial & Engineering Chemistry Research
1 October 2014 in SPE Journal
Summary: Because of increasing energy demand, unconventional resources such as heavy oil are being explored and recovered. Enhanced-oil-recovery (EOR) methods such as surfactants and polymer flooding must be optimized and new chemicals must be designed to produce more oil. This paper introduces a new deep eutectic solvent (DES) that is based on choline chloride/ethylene glycol for EOR. As preliminary investigations revealed, different concentrations of DES solutions in brine (0 to 100 vol%) were characterized by measuring density, viscosity, conductivity, surface tension, and refractive index at different temperatures (25 to 55°C). Then, the effects of the DES/brine solutions on emulsification with oil phase, wettability alteration, oil/solvent interfacial tension (IFT), formation damage, and tertiary heavy-oil recovery were studied. Potential of the DES solution on enhancing heavy-oil recovery was explored by use of coreflood experiments. This was performed at reservoir condition (pressure = 1,200 psi, temperature = 45 to 80°C) with Berea sandstone core samples and fluids from the field of interest (formation brine and crude oil). An increase in IFT rather than a decrease was observed between the DES/brine solution and the oil. The spontaneous-water-imbibition tests suggested that a decrease in oil-wetness led to an increase in oil production. Approximately 52% of residual oil after waterflooding was recovered with the DES from the coreflooding. The results show an increase in oil recovery with reservoir temperature (6, 13, and 16% on the basis of initial oil in place at 45, 60 and 80°C, respectively). The interaction of the DES with the core materials did not lead to formation damage, as demonstrated by the permeability measurements of the DES/brine solution before and after injection. Viscous forces and wettability alteration were found to be the dominant mechanisms for the tertiary oil-recovery enhancement.
1 January 2019 in International Journal of Oil, Gas and Coal Technology
This study investigates the potential of deep eutectic solvents (DES) to recover the residual oil left after waterflooding. For the first time to our knowledge, the effectiveness of two DESs - choline chloride-malonic acid of molar ratios 1:1 and 1:0.5 - in enhancing oil recovery was investigated. The solvents were characterised by measuring density, viscosity, conductivity and pH at different temperatures. Also, measurements of interfacial tension, wettability alteration, spontaneous water imbibition, emulsification, core flood and formation damage tests were conducted at different temperatures. The core flood tests were carried out at reservoir condition using Berea sandstone cores and fluids from the field of interest. Results showed the solvents produced 7%-14% of the residual heavy oil after brine flooding as tertiary recovery stage and without causing any formation damage. Both DESs showed better performance at higher temperatures. Wettability alteration was found to be the dominant mechanism for the oil recovery enhancement. [Received: October 4, 2015; Accepted: October 15, 2016]
20 June 2019 in Applied Petrochemical Research
Converting plastic wastes into fuels through catalytic cracking is continuously gaining interest from researchers worldwide. In this study, the influence of iron on ZSM-5 (Fe-ZSM-5) catalyst on the reforming of the gaseous products of thermal decomposition of low-density polyethylene (LDPE) was investigated. The acidified ZSM-5 catalysts (0, 0.3, 0.6 and 1 wt% of Fe) were prepared and characterized by XRD, BET, FTIR and SEM techniques. In particular, the effects of temperature (400, 450 and 500 °C) and catalyst loading (0.5, 0.75, 1.0, 1.25 and 1.5 g) on a two-stage (pyrolyser and reformer) decomposition of the LDPE wastes into fuel were studied. The liquid fraction produced was characterized using FTIR and GC/MS techniques. The study showed that the increase in pyrolysis temperature (400–500 °C) increases the volume of non-condensable gas (31–58 wt%) and decreases the volume of the condensates (69–41 wt%) in both the thermal and catalytic pyrolyses. However, the trend was at higher level for the catalytic pyrolysis. The increase in temperature for the thermal pyrolysis had less significant effect on the aromatization content of the liquid condensate compared to the catalytic pyrolysis. The FTIR results show a significant increase in aromatic contents and decrease in the aliphatic of the liquid fraction for the catalytic pyrolysis reforming when compared with thermal pyrolysis. The GC/MS results confirmed the aromatic hydrocarbon compositions, predominantly p-xylene, increased relatively to about 70% in the liquid fraction for the best catalyst (1.25 g of catalyst and 1 wt% iron loading on ZSM-5 at 450 °C).
15 January 2018 in Nigerian Journal of Technology
Hydrogenation of toluene on Ni-Co-Mo supported zeolite catalysts