1 December 2022 in Physics of Fluids
Real-time bubble behavior characterization is critical in the chemical industry, especially for leakage in sodium–water reactions. In this study, the injection of gas into sodium flows was conducted to evaluate bubble characterization methods. Simulation research was performed to dynamically characterize bubble generation, growth and bursting in flowing sodium, and experimental research was conducted to explore the time-frequency and time domain statistical characteristics of bubble signals. After gas injection, significant low-amplitude signals were observed in the time domain, the power spectral density fluctuated in the 0–20 kHz band; its spectral components were more abundant above 8 kHz, and the short-time Fourier transform of the energy spectrum exhibited a nonlinear intermittent distribution in the 8–20 kHz band. Based on these differences, the bubble signal was effectively detected when the gas injection rate was 0.11 m3/h with a signal-to-noise ratio less than 0.5 dB. Thus, this study complemented the present techniques and knowledge in the field of chemical engineering.
15 February 2021 in International Journal of Turbo & Jet-Engines
Aiming at the problem of aerodynamic coupling interference between disturbance of the built-in measurement probe and internal flow of high load compressor, the experiment of axial position and structure dimension of cylindrical probe support effect on the performance of the compressor cascade was carried out on the transonic plane cascade test facility. The effect characteristics of the distribution of probe support on aerodynamic performance of downstream cascade under different inlet Mach numbers were analyzed through the experimental data. The experimental results show that the axial position of probe support has little impact on the total pressure loss coefficient of cascade under the low-speed inlet flow condition. However, the variety of the axial position of probe support has a great impact on the total pressure loss coefficient of cascade under the high-speed inlet flow condition. With the decrease of the axial distance between probe support and cascade, the total pressure loss coefficient of cascade increases. Under different inlet flow conditions, the variety of the structure dimension of probe support has a significant impact on the total pressure loss coefficient of cascade. With the increase of the structure dimension of probe support, the total pressure loss coefficient of cascade increases.