Growing water stress has led to emerging interest in protecting fresh and brackish groundwater as a potential supplement to water supplies and raised questions about factors that could affect the future quality of fresh and brackish aquifers. Limited well infrastructure, particularly in regions where elevated salinity has led to limited historical groundwater development, hinders traditional mapping of salinity distributions through groundwater sampling. This paper presents a quantitative salinity mapping approach of the upper 300 m using high‐resolution, regionally comprehensive resistivity models derived from Bayesian inversion of an airborne electromagnetic survey adjacent to the Lost Hills and Belridge oil fields in the southwestern San Joaquin Valley of California. Using local water quality observations as an interpretational foundation, a probabilistic approach yields maps of fresh, saline, and brackish groundwater while quantifying joint uncertainty inherited from the geophysical data and interpretational relations. Saline and fresh regions are mapped with relatively high confidence in many locations, while areas of lower confidence, particularly at depth, can be mapped as their most probable salinity category while reflecting the relative uncertainty in the interpretation. These maps identify a stratified salinity structure, where saline water commonly occurs in the surficial aquifer overlying fresher groundwater in the Tulare aquifer, separated by regional confining clay layers. Downgradient of unlined surface water diversions, recharge of imported surface water results in relatively fresh groundwater throughout the depth of investigation.
The major processes controlling groundwater flow in intermountain basins are poorly understood, particularly in basins underlain by folded and faulted bedrock and under regionally realistic hydrogeologic heterogeneity. To explore the role of hydrogeologic heterogeneity and poorly constrained mountain hydrologic conditions on regional groundwater flow in contracted intermountain basins, a series of 3‐D numerical groundwater flow models were developed using the South Park basin, Colorado, USA as a proxy. The models were used to identify the relative importance of different recharge processes to major aquifers, to estimate typical groundwater circulation depths, and to explore hydrogeologic communication between mountain and valley hydrogeologic landscapes. Modeling results show that mountain landscapes develop topographically controlled and predominantly local‐scale to intermediate‐scale flow systems. Permeability heterogeneity of the fold and fault belt and decreased topographic roughness led to permeability controlled flow systems in the valley. The structural position of major aquifers in the valley fold and fault belt was found to control the relative importance of different recharge mechanisms. Alternative mountain recharge model scenarios showed that higher mountain recharge rates led to higher mountain water table elevations and increasingly prominent local flow systems, primarily resulting in increased seepage within the mountain landscape and nonlinear increases in mountain block recharge to the valley. Valley aquifers were found to be relatively insensitive to changing mountain water tables, particularly in structurally isolated aquifers inside the fold and fault belt.
The depth of active groundwater circulation is a fundamental control on stream flows and chemistry in mountain watersheds, yet it remains challenging to characterize and is rarely well constrained. We collected hydraulic conductivity, hydraulic head, temperature, chemical, noble gas, and 3H/3He groundwater age data from discrete levels in two boreholes 46 and 81 m deep in an alpine watershed, in combination with chemical and age data from shallow groundwater discharge, to discern groundwater flow rates at different depths and directly observe active and inactive groundwater. Vertical head gradients are steep (average of 0.4) and thermal profiles are consistent with typical linear conductive continental geotherms. Groundwater deeper than ∼20 m is distinct from shallow groundwater and creek water in its chemistry, noble gas signature, and age (dominantly >65 years compared to <9 years). Together these results suggest low vertical groundwater flow velocities and a relatively shallow active circulation depth of ∼20 m. This hypothesis is tested with a simple 2‐D numerical fluid flow and heat transport model representing a hillslope transect through the two boreholes. The modeling indicates that the subhorizontally bedded sedimentary rocks underlying the basin are highly anisotropic with low vertical hydraulic conductivity, and at most ∼10% of bedrock recharge (equivalent to <2% of stream baseflow) flows below a depth of 20 m. The study demonstrates the considerable value of discrete‐depth hydrogeologic, chemical, and age data for determining active circulation depth, and illustrates an approach for maximizing the utility of individual boreholes drilled for mountain bedrock aquifer characterization.