A comparison of the electronic structure of rutile (110), anatase (101), and anatase (001) single-crystal surfaces has been made using resonant photoemission and x-ray absorption spectroscopy. Under identical preparative conditions, the anatase (101) surface shows the lowest and hybridization in the states close to the valence-band maximum of the three surfaces. It also shows the highest concentration of surface-oxygen vacancies. The effect on the electronic structure of modifying the surface preparative route and thus the concentration of surface-oxygen vacancies is examined. The -antibonding hybridization (probed by XAS) is reduced by the removal of surface-oxygen. Photoemission shows that as the number of surface-defects is increased, the -bonding interaction is disrupted. For the anatase (101) surface it is found that as the number of surface-oxygen vacancies is increased, the and contributions at the valence-band maximum are reduced. We discuss the correlation between electronic structure and photocatalytic activity of the different polymorphs of .
Stainless steels are widely used as metal components owing to self-protection in aggressive environments, provided by an extremely thin surface oxide film enriched in chromium oxide. Yet, despite decades of research, the mechanisms distributing the chromium enrichment at small length scale are poorly understood, although it may cause loss of stability and local failure of the corrosion resistance. Here, we apply high resolution surface analysis to investigate at small time and length scales the nucleation and growth mechanisms of the surface oxide on a model stainless steel. Starting from an oxide-free surface, we report the direct observation of the oxide nucleation and local oxidation of chromium, which governs the nanoscale heterogeneity of the growing surface oxide by chromium pumping from the atomic terraces to the steps for preferential Cr(III) oxide nucleation and subsequently by segregation from the atomic planes below to grow the Cr(III) layer incompletely saturating the stainless steel surface. This work provides new insight on corrosion chemistry, by evidencing local chemical and structural defects self-generated at the nanoscale by the building process of the protective oxide barrier, and affecting the passive film stability.
Passivation mechanisms and the effects of controlled pre-oxidation, by exposure to oxygen at ultra-low pressure, on Cr and Mo surface enrichments were investigated on polycrystalline AISI 316L stainless steel surfaces with direct transfer between surface preparation and analysis by X-ray photoelectron spectroscopy and electrochemistry. Exposure to sulfuric acid at open circuit potential causes preferential dissolution of oxidized iron species, which promotes Cr3+ and Mo4+/6+ enrichments. Anodic passivation forces oxide film re-growth and Cr3+ dehydroxylation with no loss of Mo4+/6+ pre-enrichment. Ultra-low pressure pre-oxidation promotes Mo4+/6+ enrichment in the exchange outer hydroxide layer of the passive film, with no Mo0 depletion in the modified alloy region underneath the oxide film at open circuit potential, and under anodic passivation. Mo4+/6+ enrichment improves protectiveness against transient active dissolution during the active/passive transition.