10 December 2022 in Energy Reports
22 November 2023 in Energy Conversion and Management
19 December 2020 in Progress in Photovoltaics: Research and Applications
Molybdenum oxide (MoOx) is attractive for applications as hole‐selective contact in silicon heterojunction solar cells for its transparency and relatively high work function. However, the integration of MoOx stacked on intrinsic amorphous silicon (i)a‐Si:H layer usually exhibits some issues that are still not fully solved resulting in degradation of electrical properties. Here, we propose a novel approach to enhance the electrical properties of (i)a‐Si:H/MoOx contact. We manipulate the (i)a‐Si:H interface via plasma treatment (PT) before MoOx deposition minimizing the electrical degradation without harming the optical response. Furthermore, by applying the optimized PT, we can reduce the MoOx thickness down to 3.5 nm with both open‐circuit voltage and fill factor improvements. Our findings suggest that the PT mitigates the decrease of the effective work function of the MoOx (WFMoOx) thin layer when deposited on (i)a‐Si:H. To support our hypothesis, we carry out electrical simulations inserting a dipole at the (i)a‐Si:H/MoOx interface accounting the attenuation of WFMoOx caused by both MoOx thickness and dipole. Our calculations confirm the experimental trends and thus provide deep insight in critical transport issues. Temperature‐dependent J‐V measurements demonstrate that the use of PT improves the energy alignment for an efficient hole transport.
24 January 2023 in Solar Energy
23 March 2022 in Progress in Photovoltaics: Research and Applications
Monitoring residential scale photovoltaic (PV) systems is important for maximizing the energy yield and detecting malfunctions. Analytical‐based approaches are not reliable in these systems because of the lack of on‐site measurements and detailed PV system specifications. In this paper, a collaborative approach is proposed which does not depend on weather data but on similar PV systems. Based on the so‐called performance‐to‐peer approach, the aim of this work is to improve this baseline model by adding PV systems characteristics and by optimizing with machine learning techniques. The methodology has been tested in a fleet of more than 12,000 PV systems located in the Netherlands with up to 7 years of data per system. The proposed model achieves an average of 94.1% and a NRMSE of 0.05, outperforming in terms of the baseline model by 1.4 points, and the analytical approach by 3.8. The data requirements of this model are not high: With 1,700 years of PV system data with daily resolution, the maximum performance can be achieved as long as a minimum of 6 months of data per system and 100 PV systems are considered. The application of this model for fault detection and categorization has also been shown. The proposed approach has shown its strengths with respect to other methods through its ability of distinguishing between system mismatch and actual fault and of adapting to new situations via retraining.