14 March 2024 in IEEE Transactions on Electron Devices
We have developed atomic layer deposition (ALD) process of InGaOx (IGO) and InSnOx for transistor channel and electrode and investigated the tradeoff among mobility, electrostatics, and reliability in single-gate (SG) IGO FETs. Threshold voltage ( $\textit{V}_{\text{th}}$ ) shift after positive gate bias was observed especially in high Ga concentration and thin IGO channel devices, which can be attributed to excess oxygen. We also extracted interface and bulk state density ( $\textit{D}_{\text{it}}$ and $\textit{N}_{\text{bulk}}$ ) using the subthreshold swing (SS) measurement results from the channel thickness dependence. $\textit{D}_{\text{it}}$ is as low as 1–2 $\times$ 10 $^{\text{11}}$ cm $^{-\text{2}}$ eV $^{-\text{1}}$ , which means the formation of the defect-less interface between IGO channel and HfO $_{\text{2}}$ gate dielectric. Ga concentration dependence of $\textit{N}_{\text{bulk}}$ indicates the impact of O $_{\text{2}}$ dimer generation in high Ga concentration devices. To break the characteristics tradeoff, we fabricated multigate nanosheet (NS) IGO FETs and demonstrated normally OFF operation, high mobility ( $>$ 30 cm $^{\text{2}}$ /Vs), and high reliability. The drive current of the double-gate (DG) IGO FET is 2.2 times higher and the mobility is 1.2 times higher than that of the SG IGO FET, thanks to the multichannel structure and excess oxygen reduction by passivation process. The difference in positive bias instability (PBI) and negative bias instability (NBI) degradation between SG and DG structure was discussed by comparing the electric field distribution of TCAD simulation results of SG and DG IGO FET. This work shows the most well-balanced performance among preceding ALD IGO FETs with respect to mobility, $\textit{V}_{\text{th}}$ , and SS, and shows the possibility of future 3-D back end of line (BEOL) monolithic and 3-D memory integration using ALD IGO channel.
18 October 2024 in IEEE Transactions on Electron Devices
We have investigated the scaling potential of nanosheet oxide semiconductor FETs (NS OS FETs) for monolithic 3-D (M3D) integration in terms of atomic layer deposition (ALD) material engineering, high-field transport, and statistical variability. We have developed and systematically compared InGaO (IGO), InZnO (IZO), and InGaZnO (IGZO) FETs by ALD. The effective mobility ( $\mu_{\text{eff}}$ ) characteristics of IGZO are higher than that of IGO and IZO at the same threshold voltage ( $\textit{V}_{\text{th}}$ ) in the normally-OFF region ( $\textit{V}_{\text{th}}$ $>$ 0). IGZO benefits from high $\mu_{\text{eff}}$ of IZO and low oxygen vacancy ( $\textit{V}_{\text{o}}$ ) of IGO and thus shows well-balanced characteristics. To study the carrier transport characteristics under a high electrical field, we have fabricated sub-100 nm gate length NS OS FETs and extracted transconductance ( $\textit{g}_{\text{m}}$ ) as a metric. While bulk Si FETs show velocity saturation behavior even after parasitic correction, NS OS FETs show unsaturated velocity behavior. We also have obtained statistical variability data of NS OS FETs, which is comparable against bulk Si nFETs and Si SOI nFETs. This work provides evidence of the scalability of NS OS FETs for M3D integration.