3 November 2017 in Journal of Fluids Engineering
This paper presents the capability of a numerical code, isis-cfd, based on the solution of the Navier–Stokes equations, for the investigation on the hydrodynamic characteristics of a marine propeller in open water. Two propellers are investigated: the Istituto Nazionale per Studi ed Esperienze di Architectura Navale (INSEAN) E779A model in straight-ahead flow and the Potsdam Propeller Test Case (PPTC) model in oblique flow. The objectives of this study are to establish capabilities of various turbulent closures to predict the wake propeller and to predict the instability processes in the wake if it exists. Two Reynolds-averaged Navier–Stokes (RANS) models are used: the k–ω shear stress transport (SST) of Menter and an anisotropic two-equation explicit algebraic Reynolds stress model (EARSM). A hybrid RANS–large eddy simulation (LES) model is also used. Computational results for global flow quantities are discussed and compared with experimental data. These quantities are in good agreement with the measured data. The hybrid RANS–LES model allows to capture the evolution of the tip vortices. For the INSEAN E779A model, the instability of the wake is only predicted with a hybrid RANS–LES model, and the position of these instabilities is in good agreement with the experimental visualizations.
11 May 2013 in Journal of Marine Science and Technology
15 January 2009 in Journal of Fluids Engineering
A prior analysis of the effect of steady cross wind on full size cars or models must be conducted when dealing with transient cross wind gust effects on automobiles. The experimental and numerical tests presented in this paper are performed on the Willy square-back test model. This model is realistic compared with a van-type vehicle; its plane underbody surface is parallel to the ground, and separations are limited to the base for moderated yaw angles. Experiments were carried out in the semi-open test section at the Conservatoire National des Arts et Métiers, and computations were performed at the Ecole Centrale de Nantes (ECN). The ISIS-CFD flow solver, developed by the CFD Department of the Fluid Mechanics Laboratory of ECN, used the incompressible unsteady Reynolds-averaged Navier–Stokes equations. In this paper, the results of experiments obtained at a Reynolds number of are compared with numerical data at the same Reynolds number for steady flows. In both the experiments and numerical results, the yaw angle varies from 0 deg to 30 deg. The comparison between experimental and numerical results obtained for aerodynamic forces, wall pressures, and total pressure maps shows that the unsteady ISIS-CFD solver correctly reflects the physics of steady three-dimensional separated flows around bluff bodies. This encouraging result allows us to move to a second step dealing with the analysis of unsteady separated flows around the Willy model.
8 November 2018 in Journal of Fluids Engineering
Collaboration is described on assessment of computational fluid dynamics (CFD) predictions for surface combatant model 5415 at static drift β = 0 deg and 20 deg using recent tomographic particle image velocimetry (TPIV) experiments. Assessment includes N-version verification and validation to determine the confidence intervals for CFD solutions/codes, and vortex onset, progression, instability, and turbulent kinetic energy (TKE) budget analysis. The increase in β shows the following trends. Forces and moment increase quadratically/cubically, and become unsteady due to shear layer, Karman and flapping instabilities on the bow. Wave elevation becomes asymmetric; its amplitude increases, but the total wave elevation angle remains same. The vortex strength and TKE increase by about two orders of magnitude, and for large β, the primary vortices exhibit helical mode instability similar to those for delta wings. Forces and moment for both β and wave elevation for β = 0 deg are compared within 4% of the data, and are validated at 7% interval. Wave elevation for β = 20 deg, and vortex core location and velocities for both β are compared within 9% of the data, and are validated at 12% interval. The vortex strength and TKE predictions show large 70% errors and equally large scatter and are not validated. Thus, both errors and scatter need reduction. TKE budgets show transport of turbulence into the separation bubble similar to canonical cases, but pressure transport is dominant for ship flows. Improved CFD predictions require better grids and/or turbulence models. Investigations of solution-adaptive mesh refinement for better grid design and hybrid Reynolds-averaged Navier-Stokes/large eddy simulation models for improved turbulent flow predictions are highest priority.
14 October 2021 in Computers & Fluids
1 January 1999 in AIAA Journal