7 May 2022 in Computers and Electronics in Agriculture
26 December 2018 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
A model is proposed to calculate load distribution over threads of planetary roller screw mechanism (PRSM) with pitch deviation. Firstly, four kinds of machining errors of threads including pitch deviation, deviation of thread angle, division error of multiple threads and deviation of pitch diameter are analyzed, and the relationships among them are investigated. After analyzing the relationships among the errors, pitch deviation is chosen to be the main machining error to investigate because it can reflect the effects of other machining errors, and is the most influential machining error on the contact condition and deformation compatibility relationship, i.e. the load distribution of PRSM. Based on the proposed model, the effects of pitch deviation on the load distribution of PRSM are studied through numerical analyses, and load distributions under different machining precisions are analyzed. In order to experimentally verify the investigation, two PRSM samples are measured and tested under the same experimental conditions. The experimental results show that load distributions over threads will fluctuate because of the existence of pitch deviations. The pitch deviations, load distributions over threads and wear depths of threads in the samples show obvious accordance, which indirectly demonstrates the effects of pitch deviation on load distribution.
1 August 2018 in Xibei Gongye Daxue Xuebao/Journal of Northwestern Polytechnical University
Based on the relationship between the load distribution and the load deformation of the thread of the planetary roller screw mechanism (PRSM), a modification method of the roller thread is proposed. The nut side and the screw side of the roller thread are modified by different amount of modification, and the modified thread load distribution is calculated and analyzed. The results show that the effects of roller thread modification on the load distribution are significant, and the sensitivity of the load capacity of the nut and screw to the modification is different. Through the study of the influence of roller thread modification on thread load distribution, the optimal value of the roller thread modification on the nut side and the screw side is obtained under the PRSM parameters given in this paper, which provides a theoretical guidance for the future PRSM load balancing design.
1 September 2014 in Advances in Mechanical Engineering
Throwing device is an important factor that directly affects the performance of chaff cutter. In this work, the dynamic analysis linked with the problem of low efficiency and residue blockage of disc knife chaff cutter is executed. Based on this perspective, the mathematical model, simulation, and testing of the material movement have been carried out. Simulations are performed in MATLAB/Simulink environment. An anemometer records the airflow velocity, which provides data for simulation analysis. The simulation results showed that during the movement along the blade, the material first performs deceleration and then accelerates; in other stages, only deceleration. And finally calculated the throwing distance. To support the presented simulations, an experimental study is conducted. The experimental results are compared with simulation results, the maximum relative error between the simulated value and the experimental value is 9.42%, which verified the correctness of the model. This research provides a theoretical basis for the structural design, parameter optimization, and matching of the chaff cutter.