1 January 2018 in Journal of Clinical and Experimental Dentistry
Renal failure is a process that expresses a loss of functional capacity of the nephrons, independently of its etiology. The most widely used technique to combat renal failure is hemodialysis. Renal failure causes various systemic alterations including oral complications such as variations in the flow and composition of the saliva. Caries is a multifactorial disease and impaired stimulated salivary flow rate and buffering capacity are the best-known risk factors. The present study aims to evaluate the salivary pH, buffering capacity and the flow rate of saliva to the DMFT status in adult hemodialysis patients among the Indian population. Twenty healthy individuals and sixty patients undergoing hemodialysis were divided into four groups based on the following criteria: Group 1: Control group; healthy individuals,Group 2: Patients before undergoing dialysis or undergoing dialysis2 years. Dental examinations were performed according to the modified WHO oral health survey 2013 criteria and DMFT index. Saliva was collected after pre-stimulation to measuring the flow rate, buffering capacity and pH. The results exhibited a decrease in the salivary flow rate and buffering capacity with the increase in the time interval of hemodialysis, but salivary pH was found to be increasing with time. A direct relationship was seen between the DMFT scores with the increasing time interval. There was a significant correlation between DMFT index, stimulated salivary flow rate, and buffering capacity in the patients. Oral health impairment can beacon to grave problems in infection-prone hemodialysis patients. Hence, the patients on hemodialysis should have regular dental examinations and treatment. Regular dental examination and instruction in patients awaiting a renal transplantation is of vital importance to ensure optimal oral health. Key words:Saliva, pH, Buffering Capacity, Flow Rate, Hemodialysis, DMFT.
21 September 2023 in Acta Microbiologica Et Immunologica Hungarica
Irreversible pulpitis is an inflammation of the tooth pulp caused by an opportunity-driven invasion of the pulp space by oral microbiota typically prevalent in the oral cavity. Microbial organisms are extensively recognised to be the fundamental cause of endodontic infections and treatment failures. Previously, bacterial species responsible for these infections were largely recognised using conventional microbial culture techniques, lending credence to the widely held belief that anaerobic Gram-negative bacteria frequently enter the pulp space and trigger endodontic infections. The advent of novel technologies grants the advantage of detecting and studying microbial populations via an amalgamation of the modern “Omics” techniques and meticulous bioinformatics analysis, additionally detecting the metatranscriptome, metaproteome and metabolome along with the metagenome. Amongst these analytical strategies, metagenomic analyses are essentially pragmatic for investigating the oral microbiome. Metagenomics favor not only assessment of microbial composition in diseased conditions, but also contributes to detection of novel, potentially pathogenic species inclusive of non-viable bacteria. The present review describes current knowledge of root canal microbiome, including its composition and functional attributes, the novel strategies available for detection of microbiome as well as challenges associated and provides some crucial pointers for areas of future research.
26 September 2023 in World Academy of Sciences Journal
The decalcification of teeth constitutes a persistent challenge for pathology and histology research laboratories. The conflict concerning the duration of the procedure and the fineness of the sections render it fundamentally challenging. The present study aimed to introduce a novel method for decalcifying teeth using a magnetic agitator. For this purpose, 192 non‑carious premolars extracted for orthodontic treatment were collected and fixed immediately with 10% formalin. The apical tips of all the samples were removed. A total of four decalcifying agents (DAs) were selected for decalcification: 5% Nitric acid (group I), 10% HCl (group II), 10% formic acid (group III) and 14% EDTA (group IV). The samples were decalcified separately by the same solution, one with and one without agitation with a magnetic agitator. The solutions were changed daily to accelerate decalcification. The decalcification rate (DR) was higher in group I, followed by groups II, III and IV. There was a statistically significant difference between the groups as regards the DR. Agitation significantly reduced the decalcification time for all the DAs used. Tissue preservation following decalcification was sufficient with the group IV solutions, average with those used in groups II and III, and poor with the group I solutions. Tissue preservation was improved in the sections subjected to agitation than in those without. On the whole, the results of the present study suggest that 14% EDTA can decalcify at an accepted rate and provides satisfactory tissue details for decalcifying healthy premolars with an agitation speed at 100 rpm. However, further studies are required to rule out the effects of this DA on carious, malformed teeth associated with pathologies, normal and pathological bone.
1 December 2016 in Journal of Health and Allied Sciences NU
Aim: The study aimed to assess and investigate the effect of electron beam irradiation on the flexural strength of two newer nanocomposites (Filtek Z350XT and Filtek Bulkfill) Materials and Methods: Forty samples each of both the nanocomposites were prepared on rectangular bar shaped moulds (25*2*2mm) according to ISO 4049. The dosage of electron beam selected for the study were 2KGy, 4KGy and 10KGy. The forty specimens were divided into four groups based on the radiation doses; group I: non radiated, group II: 2KGy , group II: 4 KGy, group II: 10KGy with ten samples in each group. The samples were subjected to a 3point bend test on a universal uniaxial servo mechanical testing machine. Results: The data was statistically analyzed using One way Anova analysis. Analysis demonstrated that Filtek Z350XT had better flexural strength than Filtek Bulkfill (P<0.001). The flexural strength of the composites increased with the dose of electron beam irradiation. Conclusion: Within the limitations of the study, it can be concluded that the electron beam irradiation of the nanocomposites can be used as a tool to enhance their mechanical properties.
1 January 2020 in Research Journal of Pharmacy and Technology
Aim To evaluate the effect of delayed tooth brushing with different concentrations of carbamide peroxide on enamel surface roughness. Materials and Methods Ninety extracted human permanent premolars were disinfected and the roots were cut at the cemento-enamel junction into 2mm thick enamel slabs measuring 6x4mm were prepared from the middle third of buccal and lingual aspects with the use of double sided diamond discs. One hundred eighty enamel slabs were prepared from ninety permanent extracted human premolars. These one hundred eighty enamel slabs were divided into 3 groups (n=60) based on 3 percentages of carbamide peroxide-15%, 25%, 35%. Every group was again divided into 3 subgroups (n=20)-A, B, C. The subgroup A served as control, subgroup B and subgroup C was based on the time interval of tooth brushing. The initial surface roughness was evaluated using stylus profilometer. For 21days the procedures involving bleaching, brushing and rinsing were continued in all the groups. Once again at the end of 21days, the surface roughness values for the specimens were measured. Results Before the study was initiated the means of surface roughness in all the groups were evaluated. The non-parametric Kruskal Wallis test showed significant differences between the groups. The results that the differences in the means of the surface roughness values before and after intervention showed significant differences between the groups under study (p<0.001). The Mann Whitney U test revealed significant differences in the means of surface roughness values of immediately brushed group and the other groups. Group 1 showed least surface roughness were as Group 3 showed increased surface roughness. Conclusion Among the different concentrations of bleaching agents available today it is always better and safer to use bleaching agents with lower concentrations. Also. delaying the oral hygiene procedures after bleaching should always be considered to help us in achieving better results.
13 December 2025 in BMC Oral Health
Contemporary molecular analytical methodologies have yielded insufficient characterization of the microbial etiology underlying chronic irreversible pulpit