Lithium-excess disordered rock salt (DRX) materials are promising candidates for Co/Ni-free Li-ion cathodes due to their high specific energy (800+ W h kg−1) and compositional flexibility. DRX cathodes are typically synthesized using solid-state reactions, which are difficult to scale and provide little-to-no control over particle morphology. To address this bottleneck, the present study reports a two-step, solution-based reaction route to prepare Mn/Ti-based DRX oxyfluoride cathodes with nominal compositions of Li1.25Mn0.5Ti0.3O1.95F0.05 and Li1.35Mn0.7Ti0.1O1.85F0.15. More specifically, a glycine–nitrate combustion reaction is used to produce a lithiated transition metal oxide, which is further reacted with LiF to produce high-purity DRX powders. Remarkably, this route yields 80–90% pure DRX after annealing for 1 h at 800–1000 °C, and 19F solid-state nuclear magnetic resonance (ssNMR) spectra demonstrate that F− anions are successfully incorporated into the DRX structure. Cathodes prepared using this approach exhibit promising electrochemical performance, with Li1.35Mn0.7Ti0.1O1.85F0.15 attaining reversible capacities ∼210 mA h g−1 and moderate cycling stability in half cells (65% capacity retention over 150 cycles). Overall, these results demonstrate that utilizing novel metal oxide precursors presents a viable and largely unexplored method to produce high-performance Co/Ni-free DRX cathodes.
Inorganic fillers play an important role in improving the ionic conductivity of solid composite electrolytes (SCEs) for Li‐ion batteries. Among inorganic fillers, perovskite‐type lithium lanthanum titanate (LLTO) stands out for its high bulk Li+ conductivity on the order of 10−3 S cm−1 at room temperature. According to a literature survey, the optimal LLTO filler should possess the following characteristics: i) a single‐crystal structure to minimize grain boundaries; ii) a small particle size to increase the filler/polymer interface area; iii) a 1D morphology for efficient interface channels; and iv) cubic symmetry to facilitate rapid bulk Li+ diffusion within the filler. However, the synthesis of single crystal, 1D LLTO nanomaterials with cubic symmetry is challenging. Herein, a flux strategy is developed to synthesize La0.5M0.5TiO3 (LMTO, M═Li, Na, and K) single‐crystal nanorods with an A‐site‐disordered, cubic perovskite phase. The flux media promotes the oriented growth of nanorods, prevents nanorods from sintering, and provides multiple alkali metal ion doping at M sites to stabilize the cubic phase. SCEs compositing the Li+‐conducting LMTO nanorods as fillers and poly[vinylene carbonate‐co‐lithium sulfonyl(trifluoromethane sulfonyl)imide methacrylate] matrix exhibit more than twice the conductivity of the neat polymer electrolyte (30.6 vs 14.0 µS cm−1 at 303 K).