28 May 2018 in Materials Research
AWAldoni Gabriel Wiedenhoft
Aldoni Gabriel Wiedenhoft
TRTonilson de Souza Rosendo
Tonilson de Souza Rosendo
Dissimilar Al-Cu joints are desirable due to the combination of the good electrical and thermal properties of copper with the economic advantages of aluminium. However, different chemical, mechanical and thermal properties turn dissimilar welding into a challenge with traditional fusion welding techniques. Friction stir welding appears to be a good alternative to welding dissimilar materials. Most of the works in Al-Cu FSW have been performed with Al on top. This work investigates the influence of heat input on the shear strength of aluminium-copper lap joints produced by FSW with a copper over aluminium lap configuration. Welds produced with the ω/ν rate of 200 rev.mm-1 or 500 rev.mm-1 resulted in the melting of the base materials and material leaking. Joints with shear tensile strength varying from 76 to 85% of the original resistance of AA6060 T5 were produced when the ω/ν rate was varied from 80 to 110 rev.mm-1. The fracture was governed by tension overload on the aluminium sheet, resulting in little influence of welding defects, such as tunnelling, on the joint strength.
15 December 2016 in Key Engineering Materials
Friction stir welding (FSW) is a solid state welding process that has been studied for dissimilar welding applications, especially aluminum and copper. However, the quality of dissimilar Al/Cu FSW joints is often impaired due to the formation of intermetallic compounds (IMCs), which affect both mechanical and electrical properties. This paper investigates the feasibility of FSW in producing dissimilar Al/Cu lap joints were copper is positioned over aluminum. In order to access the influence of rotational speed over the resulting joint, four different rotational speeds were tested for the same welding speed. The produced joints were then evaluated in terms of weld appearance, defects and the electrical resistance of the welded joints. Visual and ultrasound inspection indicated no discontinuity in any of the produced samples. Electrical resistance results indicate no influence of rotational speed. Moreover, electrical resistance of the Al/Cu FSW lap joints were smaller than the average between the electrical resistances of single metal joints welded with the tested materials in similar conditions. The experiments indicate that is possible to produce sound Al/Cu lap welds for the parameter window used, including the positioning of copper over aluminum, that is discouraged by literature. The small values of electrical resistance indicate no deleterious effect of IMCs over this characteristic.
1 January 2022 in ITEGAM-Journal of Engineering and Technology for Industrial Applications (ITEGAM-JETIA)
Hardox® 450 is pre-hardened structural steel with high hardness and mechanical strength, designed to resist under abrasion wear, cracks, and breakages. This material provides a longer service life for crushers, buckets, and gears due to its excellent mechanical properties, which result in low machinability. Moreover, the knowledge about machining this material is limited, justifying further investigation. Thus, this study aims to evaluate the influence of cutting speed (vc), axial depth of cut (ap), and feed per tooth (fz) on the machining forces and surface finish during the finishing end milling of Hardox® 450 with a CVD-coated carbide tool. The experiment was planned and analyzed through a 3-factor, 3-level Box-Behnken Design. The analysis of variance showed that ap was the most significant parameter for all response variables considered in this study. A multiobjective optimization was carried out to determine the ideal levels of cutting parameters, considering the lowest values of static and dynamic machining forces and average and total surface roughnesses. The model suggests that the best results are achieved with vc = 89 m/min, fz = 0.1 mm/tooth, and ap = 0.212 mm. Even with efficient results, the predicted and measured response variables differed slightly (mainly due to tool wear).
1 January 2021 in Materials Today: Proceedings
16 April 2019 in European Journal of Wood and Wood Products