Rapid conversion of tar from the Nizhnekamsk Oil Refinery in the plasma catalytic mode stimulated by microwave radiation (MWR, 2.45 ± 0.05 GHz) was studied. A quartz reactor arranged in the installation waveguide was charged with tar mixed with 15 wt % catalytic system characterized by high dielectric loss. Microwave radiation gives rise to breakdown effects on the surface of the catalytic system, followed by the plasma generation. In the plasma catalytic mode at optimum temperature of the reaction zone, 650–700°С, the tar undergoes rapid degradation with the formation of gaseous (9.3 wt %) and liquid (75.7 wt %) products and of a carbon residue containing the catalytic system (15 wt %). The maximal tar conversion is 85% upon 20-min irradiation. Analysis by gas chromatography–mass spectrometry and IR spectroscopy shows that the tar conversion products consist mainly of alkanes, alkenes, alkynes, and alkyl-substituted aromatic hydrocarbons. The solid iron-containing residue separated from the tar hydrogenation products exhibits increased ability to absorb MWR and can be used repeatedly.
1 June 2024 in Russian Journal of Applied Chemistry
Protonated diallylammonium polymers attract attention due to a number of properties, in particular high antimicrobial activity, including activity against the mycobacterium M. tuberculosis. To reduce the cytotoxic effect of polymers in the case of practical use, samples with a low MW are required. The work investigated the free radical polymerization of protonated diallylammonium monomers, diallylammonium trifluoroacetates, in excess of the initiator ammonium persulfate (10–1 M) and at average polymerization temperatures (40 and 50°C) to obtain polymers with a low degree of polymerization. It has been shown that under such conditions it is possible to obtain polymers with values suitable within the aim: 16000 < MW < 28000 g/mol. Using NMR and IR spectroscopy, it was shown that with an increase in the concentration of the initiator and, accordingly, a decrease in the molecular mass of polymers, the relative number of characteristic terminal vinyl groups decreases, and the terminal groups formed by the interaction of macroradicals with primary radicals of the initiator become predominant, in this case, sulphate groups of ammonium persulfate. The data obtained indicate that at high concentrations of the initiator, the characteristic reactions of chain transfer to the monomer are largely kinetically suppressed by the interactions of macroradicals with the primary radicals of the initiator. The approach used, which makes it possible to synthesize polymers with a low MW and terminal groups of the initiator, can be applicable in the future to vary the properties of antimicrobial activity and toxicity of polymers.
Copper-containing catalytic slurries with different concentrations of active metal precursor solutions are synthesized by drop thermolysis in situ in the hydrocarbon medium of a slurry reactor. According to dynamic light scattering, the particle size of the catalytic slurry dispersion phase is 3–4.5 nm and it remains almost unchanged during the synthesis. Using FTIR spectroscopy it is shown that the structure of precursors of slurry active species depends on the concentration of solution, which may influence the phase composition of catalytically active fragments of the surface during the reduction and synthesis of alcohols. It is demonstrated that alcohols may be synthesized from CO and H2 in the slurry reactor in the presence of the formed nanosized slurries. It is revealed that the composition of alcohol phase products differs significantly with target product selectivity being comparable: at a low concentration of precursor solution a marked amount of methanol is contained in the mixture (up to 66%), while an increase in the concentration of precursor solution causes a rise in the proportion of higher molecular weight alcohols to 88%.