11 October 2021 in Applied Physics Letters
We have built a terahertz dispersive Fourier transform spectrometer [Birch, Microchim. Acta 93, 105–122 (1987)] to study frequency properties of superconducting films used for fabrication of THz detectors. The signal reflected from the tested film is measured in time domain, which allows to separate it from the other reflections. The complex conductivity of the film depends on frequency and determines the reflection coefficient. By comparing the film reflection in the superconducting state (temperature is below Tc) with the reflection of the normal state, we characterize the film quality at terahertz frequencies. The method was applied to 70 and 200 nm thick Nb films on a silicon wafer and to 360 nm thick NbTiN films on silicon and quartz wafers. The strong-coupling coefficient, α, was found to be 3.52 for Nb and 3.71–4.02 for the NbTiN films. The experimental results were fitted using extended Mattis-Bardeen theory [Noguchi et al., Phys. Procedia 36, 318–323 (2012)] and show good agreement.
1 February 2022 in IEEE Transactions on Applied Superconductivity
We present the quality measurements of thick (thicker than London penetration depth) NbTiN superconducting films at Terahertz frequencies using a Dispersive Fourier Transform Spectrometer (DFTS). The reflected RF signal from the tested film was measured in time domain, allowing us to separate it from other reflections. The complex conductivity of the film depends on frequency and determines the reflection coefficient. By comparing the film reflection in superconducting state (film temperature below $Tc$ ) with that of the normal state (film temperature above $Tc$ ), we characterized the film quality at terahertz frequencies, and directly probed the energy of the superconducting gap of the tested film. The experimental results were fitted using the extended Mattis-Bardeen theory and th obtained film parameters show a good agreement with the literature. In addition to the DFTS, we have also measured the properties of NbTiN film using Time Domain Spectroscopy (TDS). It is shown that both TDS and DFTS provide similar results, and both techniques can be used for the quality control of thick NbTiN films. The superconducting gap determined from the measurements by both DFTS and TDS are in good agreement for both solid and meshed films showing that there is no remarkable degradation in the film quality due to technological processes of lift-off or ion etching.