A study on isolation and characterisation of cellulose nanofibre (CNF) and lignin was conducted to expand the application of CNF and lignin from oil palm biomass. CNF was extracted by steam explosion and the by-product was precipitated to obtain lignin by using the soda-pulping method. The concentrations of NaOH used for CNF by-product precipitation were 2%, 4%, and 6%. The morphology of CNF and lignin was characterised using scanning electron microscopy (SEM). The nanofibre of CNF with dimension between 50 nm and 100 nm was investigated using transmission electron microscopy (TEM). The functional group was observed using Fourier-transform infrared (FTIR) spectroscopy, showing that CNF had the structure of cellulose-I. In addition, the chemical structures of isolated and commercial lignin were analysed using 1H-NMR spectrometry. CNF had a 72% crystallinity index characterised by X-ray diffraction (XRD), while lignin showed an amorphous form. The characterisation of isolated lignin was compared with commercial lignin. The two lignins had similar particle size distribution from 1 to 100 μm. From UV-visible analysis, the lignin had aromatic rings/non-conjugated phenolic groups. The morphology of isolated lignin was rough and flaky. Commercial lignin was in powder form with near-spherical morphology. Thermogravimetric analysis (TGA) of CNF showed 30% of residue at 600 °C. The results showed a simple method to isolate CNF and lignin from oil palm empty fruit bunches.
31 August 2024 in Journal of Chemical Natural Resources
Nile Tilapia (Oreochromis niloticus) is a freshwater fish with better nutritional content compared to other freshwater fish, making it suitable for use as a source for protein hydrolysate production. Protein hydrolysate is the result of the breakdown of protein into short-chain compounds through hydrolysis. This research aims to hydrolyze the minced Nile tilapia meat using a combination of bromelain and pepsin enzymes at a concentration of 5% and pH 7 conditions for 5-6 hours. The hydrolysis results using the combination of bromelain and pepsin enzymes (B100: P0) have a yield value of 12.68%, ash content of 2.94%, protein of 57.25%, water 2.65%, and fat 10.25% with a degree of hydrolysis of 61.46%. The hydrolysate has antibacterial properties against Staphylococcus aureus and Escherichia coli bacteria with inhibition zones of approximately 8.3 mm and 8.5 mm, respectively, at a concentration of 1 (mg/µL), contains 15 types of amino acids with the highest composition being lysine 5.12% and the highest non-essential amino acid being aspartic acid 5.75%.
2 September 2024 in Journal of Chemical Natural Resources
Formulation and production of an ethanol extract derived from black turmeric (Curcuma caesia roxb) for use as an antibacterial hand sanitizer spray were successfully performed. The method used is the maceration method with 96% ethanol solvent. Formulation of rimpang kunyit hitam (Curcuma caesia roxb) ethanol extract was formulated into four formulas: without extract, 10%, 8%, and 6% ethanol extract. The results showed that the ethanol extract of black turmeric rhizome with the phytochemical screening method contained flavonoids and alkaloids, which had antibacterial activity. Formulation of rimpang kunyit hitam ethanol extract in hand sanitizer spray with a concentration of 10% has a more significant inhibition zone compared to other concentrations, namely 9.9 mm in Escherichia coli and 9.8 mm in Staphylococcus aureus bacteria.
19 August 2022 in Journal of Chemical Natural Resources
The experiment of production and characterization of an edible film by mixing tapioca starch, pumpkin (Curcubita moschatal D.), chitosan, and glycerine with applications as the wrapping of layer cake has been done. The edible film was produced by mixing 2.5 g of tapioca starch, 3.5 g of pumpkin, and 40 mL of aquadest, then adding 4 % of chitosan, and 2 mL of glycerine. After homogenous, it was poured into an acrylic pan and dried in an oven at 35-45°C degrees for 2 days. Characterization of an edible film physically obtained thickness was 0.25 mm, tensile strength was 0.06 kgF/mm2 and elongation was 22.77 %. Morphology test of SEM (Scanning Electron Microscopy) produces edible film have pores that were tight, flat, and a bit compatible surface. And the FT-IR spectrum analysis showed the spectrum at 2939.52 cm-1 for the Alkana group (CH) and 3402.43 cm-1 for the hydroxyl group (OH). The result of the nutrition analysis of edible film was 28.2 % of carbohydrate content, 8.23 % protein content, 1.49 % of fat content, 25.6 % of water content, and 0.36% of ash content. An edible film can also be used as a wrapping for a layer cake.
23 August 2022 in Journal of Chemical Natural Resources
The preparation of edible film from carrot extracts (Daucus Carota, L) with the addition of tapioca flour, wheat flour, and glycerin was carried out. The edible film was prepared by mixing carrot extract, tapioca flour, and wheat flour, and then heated and added with glycerin and stirred up. The homogeneous solution was put into an acrylic plate to form an edible film and dried in an oven at 40oC for ± 2 days. The edible film formed was characterized and analyzed its nutrition content. The tensile strength and elasticity of edible film with a ratio of 5 g tapioca flour and 5 g wheat flour were 0.1028 KgF/mm2 and 39.83% respectively. The thickness of edible film with a ratio of 2.5 g of tapioca flour and 7.5 g of wheat flour 7.5 g was 0.26 mm. The better nutrition content was found on edible film with a ratio of 5 g tapioca flour and 5 g wheat flour which has 13.94% moisture content, 2.67% ash content, 4.93% protein content, and 2.90% fat, 75.56% carbohydrate content, and 410.34 ppm carotene content. Organoleptic test edible film of color, taste, texture, and aroma gave an average score of 3 (like), because of the shiny color, crunchy taste, smooth texture, and interesting edible film. Based on the test indicated that people accepted the edible film produced.