To improve the weaknesses of large leakage and wear of dual-rotor intershaft labyrinth seal in aero-engines, the cylindrical gas film seal of metal rubber with a compliant feature is proposed to substitute this conventional seal. According to the dual-rotor operating condition, an analysis method of gas film pressure is presented considering the complex condition of rotor tilt, centrifugal expansion effect, and rotor circular precession. The characteristics of gas film pressure distribution are computed and comparisons are conducted in a complex operating state that the tilt rotor is in forward/backward circular precession under a homodromous/counter-rotating condition with/without the influence of centrifugal expansion. Besides, the formation mechanism of the gas film pressure caused by rotor rotational direction and circular precession direction is revealed. Also, the influence of rotor speed and seal ring speed on gas film pressure is analyzed when the rotor is tilted. The results indicate that for the dual-rotor cylindrical gas film seal with high rotating speed, the rotor tilt and centrifugal expansion effect have significant influence on the gas film pressure distribution, and the rotors’ rotational direction as well as rotor circular precession direction determines the maximum gas film pressure distribution area. The maximum pressure under a homodromous condition with backward precession is the highest; the maximum pressure under a homodromous condition with forward precession is the lowest. The former is 1.33% and 1.68% higher than the latter, respectively, with/without consideration of centrifugal expansion. The study method, which is generally suitable for the cylindrical gas film seal with single-rotor/dual-rotor, lays the foundation of performance analysis under complex operating conditions.
12 April 2022 in Proceedings of Global Power & Propulsion Society
Experiments were conducted on a low-speed compressor, and a set of high response transducers were mounted in the casing to collect the over-tip signal. The auto-correlation measure results show that Rc at the first half of the blade will degrade before stall. According to the phase-locked pressure contour and RMS contour at design point and near stall, the disturbance in the blade passage is caused by separation vortices, and it convects upstream from mid chord to the leading edge (LE) of the rotor and finally leads to stall. The Proper Orthogonal Decomposition (POD) can divide the pressure signal into different POD modes. The first two POD modes correspond to the blade loading, and the energy proportion of these two modes is reduced from 97% at the design point to 94% near the stall. If the proportion threshold is set at 95%, POD can generate a warning signal 350 revolutions before stall.