15 February 2023 in GPS Solutions
4 July 2025 in Measurement Science and Technology
In recent years, several Global Navigation Satellite Systems (GNSSs) have begun offering free satellite-based Precise Point Positioning (PPP) services, including Galileo’s High Accuracy Service (HAS), BDS’s PPP-B2b, and Japan’s Quasi–Zenith Satellite System (QZSS) multi-GNSS advanced orbit and clock augmentation (MADOCA). In real-time positioning correction methods, individual services are prone to interruptions and anomalies. This study proposes combining multiple correction services to enhance correction availability and continuity from the user side, thereby fully leveraging observational data from various satellite positioning services. After detecting outliers in clock corrections and standardizing reference frames across services, a Kalman filter is employed to estimate the combined clock corrections. Since GPS is currently the only GNSS supported by these services, this study incorporates GPS correction data from Galileo’s HAS, BDS’s PPP-B2b and Japan’s QZSS MADOCA in a one-week experiment. By combining satellite-based correction products from different services, users can fully utilize GNSS corrections from each. This study demonstrates that combing corrections from multiple services significantly improves their availability and continuity. The average correction availability increased from approximately 75% for a single service to 99% for combined corrections. Static and simulated kinematic experiments at Multi-GNSS Pilot Project stations show that the combination strategy improves positioning accuracy by approximately 52.7%, 10.6% and 59.1% compared to PPP-B2b, MADOCA and HAS, respectively, with convergence time reductions of 48.5%, 37.1% and 67.1%. Marine experiment results with an unmanned underwater vehicle demonstrate that the combination strategy improves horizontal positioning accuracy by 19.7%, 59.1% and 17.8%, and vertical positioning accuracy by 54.1%, 77.8% and 1.2% compared to PPP-B2b, HAS and MADOCA.
22 September 2025 in Measurement Science and Technology
Outlier detection and mitigation in satellite clock offsets are prerequisites for ensuring high-precision positioning and timing services. This paper proposes a quartile-based variance estimation method dedicated to satellite clock offset outlier detection. A systematic theoretical analysis and robustness evaluation, based on the breakdown point and influence function, are conducted and compared with the commonly used median-based and Allan variance methods. Simulation experiments reveal that the quartile-based method achieves superior accuracy with higher computational efficiency under low anomaly contamination, while the median-based method is recommended for high-anomaly scenarios. The real-time clock offset data of high accuracy service from Galileo are used to validate the outlier detection performance of the methods, and the results show both quartile-based and median-based methods achieve rapid and stable convergence, significantly outperforming sample-based and Allan variance approaches. Precise point positioning (PPP) experiments further confirm that the accuracy of horizontal PPP has significantly improved in the N-direction and E-direction, with enhancement magnitudes reaching 10%–30% in some cases based on robust variance estimation methods. However, in the U-direction, the improvement in accuracy is limited.
22 April 2025 in Measurement Science and Technology
This paper proposes an evaluation method for selecting the optimal linear combination coefficients for five-frequency cycle slip detection in BeiDou-3. First, the essence of the optimal linear combination problem for cycle slip detection is analyzed, and two linear combination constraint strategies are introduced: geometry-free ionospheric-free (GFIF) and geometry-free (GF) constraints. For the GFIF combination, a linear combination index is proposed to assess the cycle slip detection performance of different linear combinations, providing a quantitative measure for evaluating the performance of various combination coefficients. By solving the constrained optimization problem, the optimal linear combinations for phase–only geometry-free ionospheric-free (PGFIF) and phase-code geometry-free ionospheric-free (PCGFIF) are determined. For the GF combination, based on phase biases induced by cycle slips, standard deviations of cycle slip detection measurements, ionospheric delay amplification factors, and the success rate of detecting insensitive cycle slips using GFIF, suitable phase-only geometry-free combination (PGF) combinations are selected. The optimal linear combination for PGF is then determined based on the principle of minimizing the condition number. For cycle slip repair, the least squares method is used to solve for the float solution and its covariance matrix, while the LAMBDA algorithm is employed to search for the integer solution of the cycle slip. Finally, the effectiveness of the proposed method is validated through experiments using static, shipborne kinematic, ionospheric active period, and low-sampling-rate data. The experimental results demonstrate that, under five-frequency conditions, the proposed algorithm can accurately detect and repair all simulated cycle slips, confirming the feasibility and effectiveness of the method.
29 August 2024 in Measurement Science and Technology
Due to the chip shapes of Global Navigation Satellite System (GNSS) live signals differ from ideal conditions, GNSS satellite signals are distorted, which leads to different code biases, namely signal distortion biases (SDB). Existing SDB estimation methods are based on code observation combinations with large noise and face the problem of unreasonable classification, which would seriously affect the reliability of SDB estimation and correction. To solve this problem, a station-based SDB estimation method is proposed in this study. First, a full-rank linear system independent of the ionosphere is derived based on the classical Uofc model. Then, triple-frequency SDBs relative to the reference stations are estimated with three types of virtual observations. To assess and validate the performance of the proposed method, real data of 335 stations from multi-GNSS experiment (MGEX) network in January 2023 are chosen for GPS triple-frequency SDB estimation. The results show that the estimated SDBs of all stations equipped with the same receiver types keep good consistency. In addition, the estimated SDBs are shown to be related to receiver types and antenna types, and maintain high stability over the whole month. Furthermore, the code residuals of 4 zero-baselines from Curtin University CORS and the real-time kinematic (RTK) ambiguity fixing rates of 8 short baselines from the MGEX network are evaluated to validate the correction performance of the estimated SDBs. The results show that the code residuals of zero-baselines are close to zero with SDB correction, and the systematic deviations in the code residuals can be effectively decreased. For the RTK application, the ambiguity fixing rates of the selected short baselines can be increased by about 40.0% after SDB correction. In addition, the percentage of ratio values after ambiguities are fixed with SDB correction is always higher than that without SDB correction, which effectively improves the reliability of RTK ambiguity resolution.