1 March 2026 in Journal of Renewable and Sustainable Energy
Aiming at the problems of inertia scarcity and insufficient frequency support from high-penetration renewable energy grids, this paper proposes a fast frequency regulation (FR) method considering optimal allocation of voltage-sensitive controllable loads (VSCLs) through power electronics control. First, the maximum FR depth of the controllable load is calculated according to the sensitivity identification method to characterize the load FR capability. Then, the integrated system frequency response model considering source and VSCL is established. On this basis, the FR characteristic parameters satisfying the frequency extremum constraints are calculated according to the frequency change rate of the matching disturbance and sensitivity, thereby constructing an integrated FR characteristic model that considers generation, load, and storage. Further, a load FR power allocation method based on the equal voltage regulation rate is proposed. The method takes the total power of the FR characteristic model as a constraint condition to implement the VSCL power allocation with the objective of optimal voltage deviation regulation. The method requires almost no local communication, alleviating FR pressure on the source and storage sides, and can realize the rapid and effective support for the grid frequency from VSCL and energy storage. Finally, the effectiveness of the proposed method is verified by a simulation comparison of different cases.
13 February 2026 in IEEE Transactions on Smart Grid
With the widespread application of cable lines in urban distribution grids, the amplification of harmonic standing waves has become increasingly prominent, leading to significant power quality deterioration. To mitigate this issue, this paper proposes an optimal planning strategy for voltage-regulating active power filters (VRAPFs) in meshed cable distribution grids, explicitly accounting for harmonic propagation paths. First, a harmonic propagation model is established to characterize typical scenarios with varying propagation characteristics. Subsequently, K-means clustering is applied to the propagation coefficients, partitioning the distribution grid into regions where nodes exhibit similar harmonic behaviors. Within each region, the node with the highest propagation coefficient is selected as the installation site of the VRAPF to ensure uniform harmonic suppression. Furthermore, the operational parameters of the VRAPF are optimized to simultaneously satisfy network performance requirements and minimize total cost. Comparative analyses with alternative site-selection strategies validate the effectiveness and superiority of the proposed approach.