The technical possibility and possible issues of an intermediate–temperature–operated polymer electrolyte fuel cell (@120 °C) is investigated with an eye toward the launching of new fuel cell heavy–duty vehicles on the world market. Commercial perfluorosulfonic acid membrane and a commercial Pt catalyst supported on carbon are selected to clarify the possible issues in the fuel cells. The cell resistivity at high humidity is less than 0.1 Ω cm–2. The mass activity (@ 0.85 V, Pt loading amount: 0.33 mgPt cm−2) approaches 850 A gPt–1. The high gas crossover rate through the membrane leads to decreased open circuit voltage, which necessitates the use of higher Pt loadings (>0.30 mgPt cm–2) at the cathode to mitigate the effect of the mixed potential. Pt degradation during 120 °C operation at low humidity is found to be much lower than that during 80 °C operation at high humidity based on the results of load–cycle durability testing.
28 December 2022 in The Journal of Physical Chemistry C
The charge and discharge performance of graphite negative and LiNi 0.5 Co 0.2 Mn 0.3 O 2 (NCM523) positive electrodes in highly concentrated 4.45 mol kg −1 LiPF 6 /propylene carbonate electrolyte solution was investigated to clarify the chemical species in the surface film formed on both electrode surfaces, and compared with those obtained with conventional 1 mol l −1 LiPF 6 /ethylene carbonate + dimethyl carbonate electrolyte solution. For the graphite negative electrode, the total electrons consumed to form surface film was well correlated with irreversible capacity, and total mole number and chemical species of the surface film were also correlated with interfacial resistance. In the conventional electrolyte solution, the reductive decomposition of solvents progressed preferentially, while LiPF 6 decomposed to form surface film in the concentrated electrolyte solution. While both organic- and inorganic-based surface films can achieve high coulombic efficiency and high capacity retention over charge/discharge cycles, the inorganic-based surface film resulted in a significant increase in interfacial resistance. As for the NCM523 positive electrode in the concentrated electrolyte solution, the formation of inorganic-based surface film and a remarkable increase in interfacial resistance were observed clearly, as with the graphite electrode. However, there was no direct correlation among mole number of chemical species in surface films formed, their chemical composition and interfacial resistance.