1 June 2018 in Journal of Optical Communications and Networking
The exponential increase in the volume of traffic being processed by datacenters demands massive electrical switches and complicated interconnections. The power consumption will soon become critical, and the problem is expected to be resolved by introducing large-port-count optical circuit switches that connect many server racks or pods. In this paper, we propose a novel optical-circuit-switch architecture that uses uniform-loss and cyclic-frequency (ULCF) arrayed-waveguide gratings (AWGs) as low-loss wavelength routers. To confirm the effectiveness of our proposal, a pair of ULCF AWGs is fabricated using planar-lightwave-circuit technology. Part of a optical circuit switch is constructed, and its good transmission performance is experimentally confirmed through 96-wavelength 100-Gbps signal transmission in the full C-band. The switch throughput reaches 153.6 Tbps.
11 March 2021 in IEEE Photonics Journal
To improve the spectral efficiency and increase network capacity, wavelength signals must be multiplexed densely, i.e. ultra-dense wavelength-division-multiplexing (WDM) networks. However, the spectrum of each WDM signal is narrowed by the wavelength-selective switches placed in optical nodes, so the transmissible distance and node hop count of the signal are strictly limited. To counter this spectrum narrowing problem caused by optical node traversal in ultra-dense WDM networks, pre-filtering techniques have been proposed. This paper comprehensively investigates the performance of four pre-filtering techniques: conventional Nyquist filtering, pre-emphasis filtering, partial-response filtering, and the combination of pre-emphasis and partial-response filtering. We conduct extensive computer simulations and discuss the optimality of pre-filtering techniques. The simulation results show that the adaptive use of pre-filtering can substantially extend the maximum attainable transmission distance and hop counts of 4/16/64-QAM signals.
1 June 2015 in Journal of Optical Communications and Networking
We propose novel highly scalable subsystem modular optical cross connect (OXC) architectures that use an efficient add/drop part to connect each transponder bank to a limited number of incoming/outgoing fibers. We investigate the performance and hardware scale of the proposed architectures in two add/drop configurations. Numerical evaluations prove that the proposed architectures attain almost the same routing performance as the equivalent conventional single large-scale OXC with an ideal colorless, directionless, and contentionless add/drop part, while enabling substantial hardware scale reduction.
16 September 2016 in Journal of Optical Communications and Networking
A novel coarse granular routing scheme for elastic optical networks is proposed in this paper, together with a node architecture and a network design algorithm. The proposed scheme allows any combination of optical paths to be routed together, and each bundle of paths, named “flexible waveband,” is routed as an entity. The flexibility in bundled paths differentiates the proposed routing scheme from optical path hierarchies proposed so far and is especially appropriate for elastic optical path networks in which frequency bandwidths of optical paths are not necessarily uniform. Path bundling at each input port of a node is realized with a small port count flexible grid wavelength selective switch (WSS), while flexible waveband routing is done by other optical switches, i.e., two-stage routing. These WSSs are only responsible for the path bundling, and their degrees need not be changed even if the number of fibers connected to a node, i.e., node fiber degree, is changed. Moreover, the number of WSSs increases linearly as the node fiber degree increases. The proposed network design algorithm resolves the routing and frequency slot assignment problem while considering specific constraints imposed by the routing scheme. Numerical experiments on several real and regular topologies confirm that the routing performance degradation caused by the coarse granularity of the routing is small while the number of WSSs is substantially reduced.
11 March 2016 in Optics Express
In order to mitigate the signal spectrum narrowing caused by optical filtering at nodes, an adequate guard band is needed between optical channels, which degrades the frequency utilization of optical fibers. In this study, we propose a grouped routing based network architecture that minimizes spectrum narrowing while greatly improving spectral efficiency. Coarse granular routing at GRE (grouped routing entity) level is employed at each ROADM node, but fine granular add/drop is adopted to retain high frequency utilization. Optical channels are packed densely in each GRE, and sufficient guard bands are inserted between GREs. As a result, signal spectrum narrowing is minimized and efficient spectrum utilization is achieved. Network design/control algorithms that support both static and dynamic traffic growth are developed. Extensive simulations demonstrate the effectiveness of the proposed architecture. To implement the scheme, current LCOS-based ROADMs are applied without any hardware changes; only the control schema are modified.