Light control of dielectric properties is very significant to develop photo-dielectric devices. Here, light-triggered “on-off” switchable dielectric constant (εr) was observed in (Bi0.5Na0.5)0.94Ba0.06TiO3 lead-free ferroelectric ceramics, exhibiting unconventional photo-dielectric effect (PDE). The effects of light switch period (2–165 min), light intensity (20–100 mW/cm2), and wavelength (450–940 nm) on PDE were studied in detail. Variation in εr exhibits remarkable switch effect with changing light on-off, while dielectric loss remains almost unchanged, and conductivity is still as low as 10−12 S/cm with excellent electrical insulation under light irradiation. The unconventional PDE exists in the high-frequency range ≥1 MHz and at the low-temperature of −100 °C. In addition to the thermal effect and light-induced change in domain behavior, it is believed that polarization of the trapped electron-hole pairs under an external electric field contributes to the increase in εr, and the low mobility of the pairs contributes to low dielectric loss and low photoconductivity. The results exhibit that dielectric constant of the lead-free ceramics can be regulated via light, whilst the ceramics keep excellent electrical insulation, endowing the lead-free ceramics potential applications in photo-dielectric devices.
5 April 2020 in Journal of Materials Science: Materials in Electronics
The dense ceramics (Na0.47Bi0.47Ba0.06)0.97Sr0.03TiO3 were sintered in nitrogen atmosphere. The weight loss during sintering is 0.2%. The mean size of grains is about 1.5 μm. The dielectric permittivity and dielectric loss of the ceramics at room temperature and 1 kHz are 1836 and 0.05, respectively. The dielectric spectra of the unpoled and poled ceramics were measured. The diffuse dielectric behavior was studied via the Curie-Weiss law and modified Curie-Weiss law. The ceramics exhibit excellent ferroelectric properties. At room temperature, the d33 is as high as 157 pC/N. The ceramics exhibit excellent temperature stability of d33 between room temperature and 115 °C.
Via the method of cold sintering with post-annealing, the lead-free ceramics [ ][ ][ ]NbO3 were prepared. The cold sintered pellet without post-annealing shows a relative density ([ ] of 77.9%, which is larger than [ ] of the green pellet via the conventional solid-state sintering (SSS) method ([ ]). The cold sintered pellets were post-annealed at temperatures between [ ]C and [ ]C. The effect of post-annealing temperatures on microstructure, dielectric, ferroelectric and piezoelectric properties of the ceramics was studied in detail. After being post-annealed, the relative densities and grain sizes of the ceramics were increased. The ceramics post-annealed at [ ]C show excellent dielectric, ferroelectric and piezoelectric properties. Compared to the conventional SSS method, the method of cold sintering with post-annealing is successful in preparing dense [ ][ ][ ]NbO3 lead-free ceramics in a wide temperature range and at relatively low temperatures.