29 January 2018 in Applied Physics Letters
JAJames Rehwaldt Alexander
The motion of domain walls in thin ferromagnetic films is of both fundamental and technological interest. In particular, the ability to use drivers other than magnetic fields to control the positions of domain walls could be exciting for memory applications. Here, we show that high frequency dynamic strain produced by surface acoustic waves is an efficient driver of magnetic domain walls in ferromagnetic films with perpendicular anisotropy. A standing surface acoustic wave of resonant frequency 96.6 MHz increases the domain wall velocities in thin films of [Co/Pt]n by an order of magnitude compared to magnetic fields alone. This effect is highly resonant, effectively ruling out thermal effects, and the velocity shows distinct variations in the domain wall velocity at the nodes and antinodes of the standing wave. The data indicate that standing strain waves can drive the domain wall motion from the creep to the flow regime as the amplitude increases. Hence, strain waves could provide an alternative route to rapid domain wall motion.
15 January 1999 in Physical Review B
The surface electronic structure in crystalline copolymer films of vinylidene fluoride (70%) with trifluoroethylene (30%) has been studied by photoemission and inverse photoemission as a function of alkali metal (sodium) doping. Sodium doping introduces at least two new states into the band (HOMO-LUMO) gap well away from the Fermi level. While the sodium-doped copolymer is observed to resemble an n-type semiconductor, the change in electronic structure with temperature suggests that dynamic distortions lead to a photoemission initial state splitting of the lower Hubbard-like bands. There is a decrease in the effective Debye temperature with sodium doping which may, in turn, enhance the dynamic Jahn-Teller distortion.
1 February 2008 in Journal of Applied Physics
X-ray diffraction and capacitance measurements have been employed to study the structural and dielectric behavior of the ferroelectric-paraelectric phase transition under the influence of a large external electric field. The samples under study are ultrathin Langmuir–Blodgett films of a copolymer of vinylidene fluoride (70%) with trifluoroethylene (30%) deposited on aluminum-coated silicon. In situ x-ray diffraction was used to measure the change in interlayer spacing perpendicular to the film surface, corresponding to the (110) direction and indicating that the polymer chains along (001) lie predominantly in the plane, while capacitance measurements were used to monitor the behavior of the dielectric constant of the film. Application of a large electric field, up to , raises the phase transition temperature and can convert the nonpolar trans-gauche paraelectric phase to the polar all-trans ferroelectric phase in a reversible manner.
18 January 1999 in Applied Physics Letters
The effective Debye temperature of poly(vinylidene fluoride-trifluoroethylene) copolymers was measured using photoemission and neutron diffraction techniques. An effective Debye temperature of is obtained from the photoemission data and from neutron diffraction measurements. This effective Debye temperature is a consequence of the temperature-dependent dynamic motions perpendicular to the surface of these crystalline polymer films.
4 January 2016 in Applied Physics Letters
The flexoelectric effect, which is a linear coupling between a strain gradient and electrical polarization, is a fundamental electromechanical property of all materials with potential for use in nanoscale devices, where strain gradients can be quite large. We report a study of the dependence of the flexoelectric response on thickness in ultrathin films of polar and non-polar polymers. The measurements of the flexoelectric response in non-polar polyethylene and the polar relaxor polymer polyvinylidene-co-trifluoroethylene-co-chlorofluoroethylene were made using a bent cantilever method and corrected for the contribution from the electrode oxide. The results show that the value of the flexoelectric coefficient increases with decreasing thickness, by up to a factor of 70 compared to the bulk value, reaching such enhanced values in films of only 10 nm thickness. These results are consistent with a model accounting for interfacial contributions, and underline how large electromechanical coupling can be produced at the nanoscale. The results also distinguish the surface flexoelectric response from that coming from the volume.
11 February 2015 in Journal of Applied Physics
A high frequency (88 MHz) traveling strain wave on a piezoelectric substrate is shown to change the magnetization direction in 40 μm wide Co bars with an aspect ratio of 103. The rapidly alternating strain wave rotates the magnetization away from the long axis into the short axis direction, via magnetoelastic coupling. Strain-induced magnetization changes have previously been demonstrated in ferroelectric/ferromagnetic heterostructures, with excellent fidelity between the ferromagnet and the ferroelectric domains, but these experiments were limited to essentially dc frequencies. Both magneto-optical Kerr effect and polarized neutron reflectivity confirm that the traveling strain wave does rotate the magnetization away from the long axis direction and both yield quantitatively similar values for the rotated magnetization. An investigation of the behavior of short axis magnetization with increasing strain wave amplitude on a series of samples with variable edge roughness suggests that the magnetization reorientation that is seen proceeds solely via coherent rotation. Polarized neutron reflectivity data provide direct experimental evidence for this model. This is consistent with expectations that domain wall motion cannot track the rapidly varying strain.