The development of (FINEMET) by Yoshizawa et al. and (NANOPERM) by Inoue et al. have shown that nanocrystalline microstructures can play an important role in the production of materials with outstanding soft magnetic properties. The FINEMET and NANOPERM materials rely on nanocrystalline and α-Fe, respectively, for their soft magnetic properties. The magnetic properties of a new class of nanocrystalline magnets are described herein. These alloys with a composition of (Fe,Co)–M–B–Cu (where M=Zr and Hf) are based on the α- and α′-FeCo phases, have been named HITPERM magnets, and offer large magnetic inductions to elevated temperatures. This report focuses on thermomagnetic properties, alternating current (ac) magnetic response, and unambiguous evidence of α′-FeCo as the nanocrystalline ferromagnetic phase, as supported by synchrotron x-ray diffraction. Synchrotron data have distinguished between the HITPERM alloy, with nanocrystallites having a B2 structure from the FINEMET alloys, with the structure, and NANOPERM alloys, with the A2 structure. Thermomagnetic data shows high magnetization to persist to the α→γ phase transformation at 980 °C. The room temperature ac permeability has been found to maintain a high value of 1800 up to a frequency of ∼2 kHz. The room temperature core loss has also been shown to be competitive with that of commercial high temperature alloys with a value of 1 W/g at and
The Heusler alloy is predicted to be a half-metallic ferromagnet and thus is considered a promising candidate for incorporation into spintronic devices. Recent theoretical calculations have shown that antisite disorder of a few percent in some Heuslers can destroy half metallicity, emphasizing the importance of characterizing samples for disorder. In this work we compare the magnetic, structural, and transport properties of for bulk single-crystal boules, polycrystalline arc-melted buttons and polycrystalline thin films. The lattice parameter, coercivity, and saturation magnetization of the single-crystal and arc-melted samples are statistically identical. On the other hand, the residual resistivity ratio shows sharp contrasts, with the single crystal and the arc-melted button having ratios of 6.5 and 2.7, respectively. Neutron-diffraction experiments show that the antisite disorder for the arc-melted samples is zero for Mn-Si antisite disorder, but between 10 and 14 % for Co-Mn antisite disorder. We postulate this to be the cause for the increased amount of defect-induced scattering in the electrical transport measurements of the arc-melted samples. The thin films, similarly, have lattice constants, magnetic properties, and room-temperature resistivities that approach those of the single crystal. The best films, however, have residual resistivity ratios of 1.4. By comparing these films to single crystalline thin films grown in other studies, we again find evidence supporting Co-Mn antisite disorder as the primary scattering mechanism.
A new class of nanocrystalline alloys with composition has been developed. This and similar alloys of general composition (Fe, Co)–M–B–Cu (where Hf, Nb, etc.) have been named HITPERM. They offer large magnetic inductions and excellent soft magnetic properties at elevated temperatures. Thermomagnetic properties, permeability, and frequency dependent losses are described in this report. These alloys exhibit high magnetization that persists to the phase transformation at 980 °C. Alternating current permeability experiments reveal a high permeability at 2 kHz with a loss value of 1 W/g at and