1 November 2021 in Journal of the Electrochemical Society
With the reduction of solid oxide fuel cell (SOFC) operating temperature to the range of 600 °C–800 °C, Cr-containing ferritic alloys have become the preferred interconnect material, which unfortunately are susceptible to continuous scale growth and Cr volatility at the SOFC operating temperatures. The (Mn,Co) 3 O 4 spinel system is widely regarded as the most effective coating for SOFC interconnect protection, due to its high thermal and electrical conductivity, adequate coefficient of thermal expansion, and excellent Cr blocking capability. This article reviews the physical and chemical properties of the (Mn,Co) 3 O 4 -based spinels; different types of coating precursors and deposition techniques; and the effects of spinel composition, quality and thickness on the coating performance. It is concluded that the spinel coating composition, quality, and thickness are more critical than the coating process in affecting the overall coating performance.
9 January 2020 in Journal of the Electrochemical Society
This study seeks to clarify the effects of off-stoichiometry on the electrical conductivity of spinels in the (Ni,Fe) 3 O 4 and (Mn,Co) 3 O 4 systems. Spinels with the compositions Ni x Fe 3–x O 4 (where x = 0.85, 0.875, 0.9, 1.0, 1.05, and 1.15) and Mn x Co 3–x O 4 (where x = 1.0, 1.2, 1.35, 1.5, 1.75, and 2.0) were prepared using conventional solid-state process. Electrical conductivity measurements were taken between 500 °C and 800 °C using the 4-point DC method. The conductivity in Ni-Fe spinels increased with increasing Fe content. Similarly, the conductivity of Mn-Co spinels increased drastically with increasing Co content. The coefficients of thermal expansion (CTEs) of these samples were also evaluated. All the (Ni,Fe) 3 O 4 spinels were found to exhibit excellent CTE matching with prospective stack components. However, thermal expansion characteristics were highly dependent on the composition in the (Mn,Co) 3 O 4 system, and only a narrow range of compositions was well-matched in CTE with prospective stack components. The significant effect of cation off-stoichiometry and sample preparation on the electrical behavior of spinels was discussed as a possible explanation for the large discrepancies in reported conductivity values for both systems.
28 May 2025 in Journal of the Electrochemical Society
Spinels based on (Mn,Co)3O4 have been shown to be effective coatings in protecting ferritic stainless-steel interconnects used for solid oxide cell (SOC) stacking. The effect of the spinel stoichiometry on the reaction layer (RL) formation is evaluated using the MnxCo3−xO4/Cr2O3 diffusion couples (where x = 1.0, 1.2, 1.35, and 1.5) in air at 900 °C. The parabolic rate constant for RL growth was observed to increase with the Mn content in the starting spinel. The electrical and thermal expansion properties of each RL composition were determined, and the projected area-specific resistances (ASRs) for each RL during long-term operation were calculated based on the obtained parabolic rate constant and electrical conductivity. Mn0.5CoCr1.5O4, which is the RL composition corresponding to x = 1.35 in the starting spinel, had both the highest conductivity and lowest CTE mismatch (i.e., σ = 3.35 S⋅cm−1 at 800 °C, CTE = 8.48 × 10–6 K−1) among the tested compositions.