Studies of crystal size distributions (CSD) can reveal much about how rocks solidify and under what conditions. Data from two-dimensional sections can be readily acquired at many different scales, from electron microscope images, thin sections, slabs, outcrops, and so on, but the conversion to true, three-dimensional values is complex. The widely used Wager method does not have a good theoretical basis and does not give accurate results. A modification of the Saltikov correction method is proposed here that is more accurate and can account for different crystal shapes and fabrics. Population densities determined by this method differ by factors of 0.02 to 100 from those determined by the Wager method. Published CSDs determined using other methods can be recalculated if the crystal shape and fabric parameters can be estimated. The method has been incorporated into a new program, CSDCorrections.
Processes involved in the development of igneous and metamorphic rocks involve some combination of crystal growth, solution, movement and deformation, which is expressed as changes in texture (microstructure). Advances in the quantification of aspects of crystalline rock textures, such as crystal size, shape, orientation and position, have opened fresh avenues of research that extend and complement the more dominant chemical and isotopic studies. This book discusses the aspects of petrological theory necessary to understand the development of crystalline rock texture. It develops the methodological basis of quantitative textural measurements and shows how much can be achieved with limited resources. Typical applications to petrological problems are discussed for each type of measurement. This book will be of great interest to all researchers and graduate students in petrology.
The Sept Iles layered intrusion (Quebec, Canada; 564 Ma) is a large plutonic body with a diameter of 80 km and a thickness of 6 km made up from its base to top of a layered series with troctolite and gabbro, and an upper border series with anorthosite, capped by cupolas of A-type granite. Chilled margin compositions suggest a ferrobasaltic parental magma close to that of the Skaergaard intrusion, but much richer in iron and titanium. Samples from drill-cores and surface sampling of the 4·7 km thick layered series reveal a succession of massive troctolites and layered gabbros that contain 24 Fe–Ti oxide layers cm- to m-thick and many anorthositic autolithic blocks. The sequence of crystallization in the layered series is: plagioclase (An72–34) and olivine (Fo75–21) followed by magnetite and ilmenite, then Ca-rich pyroxene and finally apatite. An olivine gap is observed between Fo66 and Fo59. The saturation of Fe–Ti oxides before Ca-rich pyroxene is interpreted to be the result of the high FeOt and TiO2 contents and the low CaO content of the parental magma. Contamination by old continental crust has occurred during crystallization of the layered series, as indicated by Sr isotopic compositions (87Sr/86Sr564 = 0·70360–0·70497). The differentiation trend of the intrusion is interrupted by two large and many small reversals to more primitive compositions of cumulus phases, Cr content of magnetite and lower Sr isotope ratios. These reversals and the intermittent disappearance of some phases are interpreted as resulting from magma chamber replenishments by undifferentiated primitive basaltic magma and mixing with the resident magma.
Crystal size distribution (CSD) measurements are susceptible to the closure problem, just like chemical compositions. In its simplest form this means that the total crystal content of a rock cannot exceed 100%. Where chemical or thermal effects limit the total quantity of a single phase, closure can occur at lower volumetric phase proportions. This means that parts of the CSD diagram [ln(population density) vs. size] are not accessible. If the volumetric phase proportion is constant, then straight CSDs will appear to rotate around a point at small sizes giving a fan of CSDs. These fans are significant and do show changes in crystal sizes that can be interpreted in terms of magmatic processes. However, the correlation between the slopes (or characteristic lengths) and intercepts of individual CSDs in a family is not significant, but just a consequence of the constant phase proportion effect. Many other graphs, such as characteristic length vs. volumetric phase proportion, can give more information on magmatic processes.