The interaction of ultrashort laser pulses above the ablation threshold of thin-film indium tin oxide (ITO) is examined with pump-probe microscopy. We are able to observe photomechanical spallation at delay times of hundreds of picoseconds, which plays a stronger role near the ablation threshold of 0.17 J/cm2. A phase explosion may also be observed at tens of picoseconds, playing a stronger role for increasing peak fluences. As one exceeds the material removal efficiency maximum near 0.6 J/cm2, a second spallation is observable in the center of the irradiated spot at a delay time of one nanosecond and corresponds to a crater depth of 50 nanometers. No discernable ridge formation has been observed. We recommend an industrial processing window of at least two pulses per position with a peak fluence between 0.6–1.0 J/cm2.
1 April 2021 in International Journal of Heat and Mass Transfer
We draw comparisons between the ablation and damage mechanisms that occur for both film and substrate irradiation using atomic force microscopy, scanning electron microscopy, and pump-probe reflectometry. For substrate irradiation, energy absorbed at the film-substrate interface creates a confined energy situation, resulting in a photomechanical lift-off. A partial ablation at the edges of the ablated zone formed the burr and was reduced in height by minimizing the area subject to the partial ablation threshold fluence. Substrate damage is understood to arise from free electron diffusion from indium tin oxide and subsequent laser heating. We establish a process window for substrate irradiation in a single-pulse ablation regime between approximately two to three times the ablation threshold of 0.18 J/cm2, validating the process window seen in literature and provide a crucial understanding for the ablation mechanisms of transparent conductive films.