The recent rapid growth of the semiconductor industry in development of high power microwave source has open a new promising avenue by full electronic control over the electromagnetic field towards improve the microwave heating performance. In this paper, a coupled electromagnetic and heat transfer model was built to simulate microwave heating of multiple chicken blocks with temperature-dependent dielectric properties dependent on a solid-state microwave oven. Owing to the ability of solid-state source to precisely control the frequency, the temperature distribution simulated for the fixed frequency was compared with different frequency-shifted rates increasing process and decreacsing process between 2.4GHz and 2.5GHz. The simulated temperature distribution was validated by comparing with experimental temperature profiles obtained using a thermal imaging camera at the end of microwave heating. The results demonstrated the heating uniformity and efficiency is highly influenced by the head and tail frequency but also the frequency shifted rate. And a specific frequency-shifted rate decreasing process between 2.4GHz and 2.5GHz was proposed in improving the heating performance.
13 July 2020 in IEEE Microwave and Wireless Components Letters
In this letter, a nondestructive local characterization of graphene fabricated by the reduction method on graphene oxide aqueous was demonstrated by using a near-field scanning microwave microscopy (NSMM). The dielectric properties of graphene films have been extracted to analyze the quality of graphene. Clear images of defects on graphene film were obtained by mapping the resonant frequency, fr, and quality factor, Q, of a given area. The results and images obtained demonstrate that NSMM can be employed in thin-film analysis for characterization of local electrical properties of materials in a nondestructive manner and for obtaining a map of conductivity distribution.
The limitation of mechanical manufacturing will result in a small tilt angle of the sample stage in the horizontal direction, which decreases the spatial resolution of imaging in near-field scanning microwave microscopy (NSMM). In this paper, we focus on the tilt correction and improve the spatial resolution of the NSMM image. The results of electromagnetic simulation and line scan measurement demonstrate the critical parameters affecting the sensitivity of NSMM, such as the length of the probe extending out of the cavity, the tip–sample distance, and the tip apex size. The tilt images can rotate successfully to the horizontal plane with the tilt correction methods, and the local average and re-interpolation are applied to denoise the images. Experimental NSMM images of copper thin film grid, coin texture, lithography mask, and leaf vein are obtained. The images before and after correction verify the improvement of the spatial resolution with all the above methods.