24 December 2014 in RSC Advances
The surface and interfacial properties of five zwitterionic surfactants, including three propyl sulfobetaines CSB (where the carbon atom number of the alkyl chain is 12, 14 and 16, respectively) and two hydroxypropyl sulfobetaine surfactants CHSB (where the carbon atom number of the alkyl chain is 12 and 14, respectively), were studied at both air–water and oil–water interfaces. The surface activity of these surfactants at the air–water interface in aqueous solutions was investigated by the Wilhelmy plate method at 30 °C and ambient pressure. The values of the critical micelle concentration (CMC) and surface tension at CMC (γCMC) were determined from the surface tension measurements. The obtained results indicate that CMC and surface tension strongly depend on the surfactant molecular structure. An increase in the alkyl chain length results in a decrease in the CMC and γCMC values. The presence of a hydroxyl group causes an increase in CMC values and a decrease in γCMC values. The hydroxypropyl sulfobetaine surfactants have better surfacial properties. In addition, the interfacial activity at the oil–water interface among the crude oil–reservoir water–surfactant systems was investigated by use of the spinning drop method under harsh reservoir conditions of high temperature (90 °C) and high salinity (11.52 × 104 ppm, including 7040 ppm Ca2+ and 614 ppm Mg2+). It is interesting that the transient minimum dynamic interfacial tension (DITmin) could be observed in a specific concentration range. The time to reach DITmin is different with different surfactant molecular structures and surfactant concentrations. The hydroxypropyl sulfobetaine surfactant C14HSB shows excellent interfacial properties: it can reduce interfacial tension (IFT) between oil and water to an ultralow level at a very low concentration, and the ultralow IFT phenomenon only occurs in a specific concentration range from 0.03 to 0.10 wt%. In this work, hydroxypropyl sulfobetaine surfactants exhibit remarkable ability and are good candidates for chemical agents to enhance oil recovery in harsh reservoirs.
15 November 2017 in Energy & Fuels
6 January 2015 in Colloid and Polymer Science
26 June 2018 in Physical Chemistry Chemical Physics
Natural (N-) and synthetic (S-) hectorite suspensions display significant time-dependent structural recovery behavior.
15 January 2021 in Soft Matter
Pure and composite clay gels of sepiolite and LAPONITE® at 4 wt% solids were characterised microstructurally and rheologically. They all displayed time-dependent behaviour, i.e. yield stress increased with aged time. The microstructures captured by cryo-SEM on the samples prepared by high pressure and rapid freezing showed the presence of bonding between LAPONITE® sheets and sepiolite fibres. These bonds are likely to be formed between the positive sheet edge and the negative fibre silica face as suggested by the upright orientation adopted by most LAPONITE® sheets. The sheets formed isolated open networks at a low content and a continuous open network at a high content. The fibres of the pure sepiolite gel formed a relatively strong network. However, the composite networks formed at a low LAPONITE® content between 5 and 25% must be discontinuous as the yield stress is zero. At a higher LAPONITE® content, the composite structure displayed increasing strength. The time-dependent ageing behaviour is due to the electric double layer (EDL, face–face) repulsive force governing the development of the 3D network structure. The Leong model described this behaviour well. All the clay gels displayed a maximum yield stress at a pH of 9 to 10. Pyrophosphate additive reduced the maximum yield stress and shifted the yield stress-pH curve to a lower pH. The Herschel–Bulkley model described the flow behaviour of all the gels well. The variation of the model yield stress with gel composition is similar to that obtained by the vane yield stress technique.