8 November 2020 in Journal of Low Frequency Noise, Vibration and Active Control
With the continuous service time, long-span track cable-stayed bridges are inevitably affected by material time-varying and fatigue load periodic effects, and permanent down-deflection phenomenon is inevitable. The down-deflection of the main girder would lead to the irregularity of bridge deck, which would directly affect the running comfort and safety of the train. The permanent deformation control value should be set reasonably. In this paper, based on the research and analysis of domestic and foreign codes and standards, the evaluation criteria for the service performance of long-span track cable-stayed bridges was determined, aiming at the problem of deformation classification control in the service stage of the long-span track cable-stayed bridge. The limit of permanent deformation of main girder was analyzed, and the decision processing was put forward and applied to an engineering example. According to the vehicle-bridge coupling vibration analysis, the maximum vertical deformation safety control value in the service stage is L/400, and the pre-warning control value is L/500. With the non-permanent deformation value β deducted, the permanent deformation safety control value is L/400-β, and the pre-warning control value is L/500-β. The rationality of the grading control limit of permanent deformation based on service performance analysis has been verified by application analysis.
26 March 2019 in Journal of Low Frequency Noise, Vibration and Active Control
In order to analyze the influence of the stiffness change of the long-span track bridge on running safety of the train, a bridge and train analysis model, based on Chongqing Egongyan track bridge, is established to simulate and evaluate the spatial coupling dynamic response of the wind–train–bridge system through stiffness change and to propose the reasonable stiffness limit range of the long-span track suspension bridge. The results show that the dynamic characteristics of the bridge are good, and the safety of train operation and ride comfort meet the requirements when the vertical stiffness is 1/300–1/500 and the lateral stiffness is 1/600–1/1200; the dynamic response of the bridge and the running safety of the train are significantly sensitive to the stiffness change of the bridge, especially when the wind speed is 25 m/s and the vertical stiffness is 1/300, at this time, the derailment coefficient and the wheel load reduction rate reach 0.72 and 0.54, respectively, which are close to the limit standard, indicating that there are some potential safety hazards in train operation.
1 January 2019 in International Journal of Robotics and Automation
Structural damage identification is fundamentally important for ensuring bridge safety andimproving the pertinence of maintenance work.
1 January 2017 in International Journal of Robotics and Automation
Because lack of long-term effective technical means to testprestressing loss for continuous rigid frame bridges, an automationmonitoring system based on the principle of megneto-elastic effectmethod had been built for testing prestressing loss and applied inthe Niu Lan river bridge to fulfil long-term, online and automaticmonitoring.
1 January 2021 in International Journal of Robotics and Automation
To analyse the static mechanical properties evolution law of long-span track cable-stayed bridges, an evaluation mode based onthe parameter time-dependent effect change rate was proposed toevaluate a twin-tower and double-cable plane concrete cable-stayedbridge with a main span of 250 m.