Takahiko Yanagitani

Takahiko Yanagitani

Auto-generated profile, based on publicly available information

Takahiko Yanagitani

Graduate School of Advanced Science and Engineering, Waseda University 1 , Tokyo 169-8555

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 September 2014 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
TYTakahiko Yanagitani
Takahiko Yanagitani
MSMasashi Suzuki
Masashi Suzuki
The electromechanical coupling, elastic properties, and temperature coefficient of elastic constant c33D of ScxAl(1−x)N films with high Sc concentration (x) of 0–0.70 were experimentally investigated. Near the phase boundary, a Sc0.41Al0.59N film exhibited a maximum thickness extensional mode electromechanical coupling coefficient kt2 of 12% (kt = 0.35), which is almost double the value of 6.4% for typical pure AlN films. In the region of 0 < x < 0.2, the electromechanical coupling was confirmed to increase without any detectable deterioration in the temperature stability of c33D (=−54.5 ppm/ °C). This region is favorable in terms of temperature stability and is suitable for wideband resonator filter applications.

15 July 2007 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
TYTakahiko Yanagitani
Takahiko Yanagitani
MKMasato Kiuchi
Masato Kiuchi
MMMami Matsukawa
Mami Matsukawa
YWYoshiaki Watanabe
Yoshiaki Watanabe
ZnO film, in which the crystallite c axis lies in the substrate plane [(112¯0) textured ZnO], is a good candidate for application in shear mode piezoelectric devices. The relationships between the degree of crystallites alignment and the shear mode electromechanical coupling coefficient k15 in (112¯0) textured ZnO films have been investigated. Forty pure-shear mode high overtone bulk acoustic resonators consisting of the (112¯0) textured ZnO film were prepared. The film was varied in crystallites alignment and film thickness. The degrees of crystallites alignment of the films were determined by x-ray pole figure analysis. The k15 values of the films were estimated from the conversion loss characteristics of the resonators. A significant correlation was observed between dispersion of the x-ray poles and the k15 values. However, the k15 values in the thinner films were clearly reduced as compared with those in the thicker films despite their similarities in crystallites alignment. In addition, unexpected second harmonic mode resonance was detected in the thinner films. We concluded that the piezoelectrically inactive layer in the initial film growth deteriorated the k15 value in thinner films.

15 August 2007 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
TYTakahiko Yanagitani
Takahiko Yanagitani
MKMasato Kiuchi
Masato Kiuchi
ZnO polycrystalline films have a strong tendency to grow their c -axis perpendicular to the film surface, even on an amorphous substrate. However, unusual (101¯0) preferred orientations in which the c -axis lies in the substrate plane are often observed when the film is exposed to ion irradiation during its growth. To investigate the effect of ion irradiation on the (101¯0) preferred orientation, ZnO films were fabricated using a 0–1 keV oxygen ion-beam-assisted electron-beam evaporation of zinc. The results clearly indicated that the tendency of (101¯0) preferred orientation was enhanced with increasing ion energy and amount of ion irradiation. This demonstrated that the ion bombardment induced the (0001) preferred orientation to change into a (101¯0) preferred orientation which corresponds to the ion channeling direction. An in-plane preferred orientation was also obtained, probably because of deviations in the incident ion-beam direction from 5° to the substrate surface normal. These in-plane textured (101¯0) ZnO films, fabricated under the ion-beam irradiation of 0.5–1 keV, excited a shear acoustic wave without any longitudinal wave. The highest shear mode electromechanical coupling coefficient was found to be k15=0.16 in the film with ion-beam irradiation of 1 keV. This k15 value corresponds to 60% of that in a ZnO single crystal (k15=0.26) .

27 May 2011 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Verified
Journal Article
Closed access
TYTakahiko Yanagitani
Takahiko Yanagitani
NMNaoki Morisato
Naoki Morisato
STShinji Takayanagi
Shinji Takayanagi
MMMami Matsukawa
Mami Matsukawa
YWYoshiaki Watanabe
Yoshiaki Watanabe
A method for designing frequencies and modes in ultrasonic transducers above the very-high-frequency (VHF) range is required for ultrasonic non-destructive evaluation and acoustic mass sensors. To obtain the desired longitudinal and shear wave conversion loss characteristics in the transducer, we propose the use of a c-axis zig-zag structure consisting of multilayered c-axis 23° tilted ZnO piezoelectric films. In this structure, every layer has the same thickness, and the c-axis tilt directions in odd and even layers are symmetric with respect to the film surface normal. c-axis zig-zag crystal growth was achieved by using a SiO 2 low-temperature buffer layer. The frequency characteristics of the multilayered transducer were predicted using a transmission line model based on Mason's equivalent circuit. We experimentally demonstrated two types of transducers: those exciting longitudinal and shear waves simultaneously at the same frequency, and those exciting shear waves with suppressed longitudinal waves.

28 April 2014 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
MSMasashi Suzuki
Masashi Suzuki
TYTakahiko Yanagitani
Takahiko Yanagitani
HOHiroyuki Odagawa
Hiroyuki Odagawa
Polarity inversion in wurtzite film is generally achieved by the epitaxial growth on a specific under-layer. We demonstrate polarity inversion of c-axis oriented ScAlN films by substrate ion beam irradiation without using buffer layer. Substrate ion beam irradiation was induced by either sputtering a small amount of oxide (as a negative ion source) onto the cathode or by applying a RF bias to the substrate. Polarity of the films was determined by a press test and nonlinear dielectric measurement. Second overtone thickness extensional mode acoustic resonance and suppression of fundamental mode resonance, indicating complete polarity inversion, were clearly observed in bilayer highly oriented (000-1)/(0001) ScAlN film.

2 February 2008 in Calcified Tissue International
Verified
Journal Article
Closed access
PDF file
YYYu Yamato
Yu Yamato
MMMami Matsukawa
Mami Matsukawa
TYTakahiko Yanagitani
Takahiko Yanagitani
KYKaoru Yamazaki
Kaoru Yamazaki
HMHirofumi Mizukawa
Hirofumi Mizukawa
ANAkira Nagano
Akira Nagano