The effect of the grain morphology on the photoluminescence, charge transfer band, and decay properties was investigated by x Eu 3+ , y B 3+ ( x = 10 mol%, y = 0, 5, 15, 30, 50, 70, and 100 mol%) co-doped BaTa 2 O 6 ceramics fabricated by solid-state reaction.
Eu 3+ -doped Ba 2 LaVO 6 and Ba 2 GdVO 6 phosphors show host-dependent red emission. The La-based host favors unusual 5 D 0 → 7 F 4 emission due to its flexible lattice, while the Gd-based host exhibits dominant 5 D 0 → 7 F 2 emission with improved thermal stability.
30 August 2023 in Journal of the Turkish Chemical Society Section A: Chemistry
Trivalent Eu-activated CoNb2O6 phosphors were fabricated using the molten salt method, which provides enhanced homogeneity and low sintering temperature. The ceramic samples were examined by spectral and structural analyses. In X-ray diffractions, the single phase of orthorhombic columbite type CoNb2O6 structure was obtained for 0.5-10 mol% Eu3+ doping concentrations, while a two theta peak shift towards the smaller angles occurred. SEM examinations show an irregular morphology and sub-micron grain sizes. In photoluminescence (PL) spectra, the phosphors showed typical Eu3+ emissions with the 5F0 → 7FJ (J=0, 1, 2, 3, 4) transitions, and high emission peaks were observed at the 5D0 → 7F2 transition. The photoluminescence of CoNb2O6:Eu3+ decreased over 5 mol% because of the concentration quenching. The energy transfer mechanism and critical distance of the phosphor are the dipole-dipole (d–d) interaction, and 15.70 Å, respectively. The spectral features of the phosphors were assessed by calculating the Judd-Ofelt intensity parameters (Ω2, Ω4) from the PL emission spectrum. The low Ω2 parameter values or/and the Ω4>Ω2 trend for CoNb2O6:Eu3+ phosphors were related to the less covalent or more ionic character of the Eu3+–O2˗ bond and the high local symmetry of the Eu3+ sites, while the high Ω4 parameter values may be ascribed to the decrease in the electron density in the ligands.
1 August 2022 in Hacettepe Journal of Biology and Chemistry
According to the charge balance, trivalent dysprosium doped Cdx-1Ta2O6:xDy3+ (x=0.5, 1, 2, 3, 5) phosphor series was fabricated by solid state reaction route at 1100 C for 8 h. The synthesized phosphors were investigated by XRD (X-ray diffraction), SEM (scanning electron microscopy), and PL (photoluminescence) analyses. XRD and SEM analyzes revealed the orthorhombic colombite crystal structure and the presence of oval-like and shapeless morphology with submicron and several micron grain sizes, respectively. With the excitation of 387.8 nm, the phosphors exhibited blue and yellow emissions at 482.4 nm and 578.5 nm depending on the 4F9/2→6H15/2 and 4F9/2→6H13/2 transitions of Dy3+, respectively. The concentration quenching did not occur because the improvement in the charge balance reduced the structural defects and decreased the conversion of excitation energy to non-radiative transitions. The emission intensity of cadmium tantalate phosphor increased with increasing Dy3+ ion concentration up to x=5 value, and did not occurred the concentration quenching which reduces emission intensity. The Commission Internationale d’Eclairage (CIE) coordinates of Cdx-1Ta2O6:xDy3+ (x=0.5, 1, 2, 3, 5) phosphors were found near the white region in the chromaticity diagram