8 September 2020 in Environmental Science: Water Research & Technology
Coagulation/flocculation has been grouped into three typical configurations and the impact of each examined in terms of floc properties and membrane fouling.
21 August 2023 in Separation and Purification Technology
9 December 2024 in Water Research
Calcium (Ca)-enhanced organic matter (OM) fouling of nanofiltration (NF) membranes leads to reduced flux during desalination and requires frequent cleaning. Fouling mechanisms are not fully understood, which limits the development of targeted fouling control methods. This study employed synchrotron-based X-ray fluorescence (XRF) and X-ray absorption near-edge structure (XANES) spectroscopy to quantify the spatial distribution and mass of Ca deposition as well as changes in the Ca coordination environment characteristic of specific fouling mechanisms, respectively. Bench-scale filtration experiments were performed using feed solutions containing Ca and ten different types of organic matter (OM), as well as the common scalants, calcium carbonate (CaCO3) and calcium sulfate (CaSO4). Osmotic backwash (OB) was performed at regular intervals for fouling control. Ca-OM aggregation resulted in greater flux decline and lower flux recovery during OB than Ca conditioning of membranes followed by filtration of feed solution with OM. Linear combination fitting (LCF) of XANES absorption spectra from fouled membranes indicated that Ca-OM aggregation preferentially occurred for OM types that exhibited both high carboxylic group and negative charge density. Consequently, these OM types exhibited greater deposition of Ca and TOC on the membrane surface when compared to other OM types. For the coexistence of scalants and OM, Ca speciation within the fouling layer was characteristic of both Ca bound to the membrane (i.e. potential bridging, charge screening) as well as Ca-OM aggregation and deposition mechanisms, while a range of crystal polymorphs were observed to occur simultaneously. XRF and XANES represent powerful tools for the elucidation of NF fouling mechanisms by quantification of Ca deposition as well as Ca speciation. Fouling control methods should target OM types with high carboxyl group density and negative charge to neutralize or eliminate interactions with Ca.
6 April 2025 in Water Research
Microplastics (MPs) are ubiquitous in global drinking water sources (lakes, rivers), with reported concentrations ranging from 0.5 to >7,500 particles/L. Ultrafiltration (UF), widely applied in drinking water treatment, is anticipated to represent an effective barrier to MPs due to its pore size (0.01-0.1 µm), which can retain MPs of potential health concern. To-date limited studies have reported that MPs may contribute to UF fouling, albeit when considering concentrations up to 10 orders of magnitude higher than those typically observed in source waters. The present study evaluated the retention of MPs by UF membranes when incorporating coagulation/flocculation pre-treatment, as well as their release during hydraulic and chemical cleaning. Polyethylene (PE) fragments, representing a range of environmentally relevant sizes (1-50 µm) and concentrations (907 ± 293 particles/L), were spiked into untreated lake waters prior to coagulation/flocculation-UF. Results suggest that in the absence of coagulant (alum) addition, only 50% of MPs retained during UF permeation were subsequently released during hydraulic cleaning. The release of MPs during hydraulic cleaning decreased (<20%) at medium and high (8 mg/L, 15 mg/L) alum dosages when compared to the absence of coagulant addition. Chemical cleaning with sodium hypochlorite (500 mg/L) was only capable of releasing 20% to 60% of retained MPs. Both hydraulic and chemical cleaning were less effective for the release of MPs when compared to reversible fouling resistance, organic matter, and aluminum. As such, future research is required to determine if the accumulation of MPs leads to increased UF fouling over extended operating periods, in addition cleaning practices which specifically target MPs should be further examined. Low and medium alum dosages (2 mg/L, 8 mg/L) were observed to increase the release of retained MPs during chemical cleaning, suggesting that incorporation of coagulation pre-treatment is useful to increase the release of MPs and minimize potential long-term accumulation on membranes.
9 May 2023 in Separation and Purification Technology
25 June 2026 in Water Research
Nanofiltration (NF) is an effective barrier for removing nanoplastics (NPs) from water. However, NPs can deposit on the membrane surface and remain even after backwash, altering surface properties and reducing filtration performance. In this study, laser-induced breakdown detection (LIBD) is coupled in-line with a bench-scale NF system to quantify the deposition and release of polystyrene (PS) particles and weathered NPs at environmentally relevant concentrations (1-500 µg/L; 107-109 particles/mL). Particle deposition during filtration and release during backwash were successfully determined in all experiments, supported by theoretical analysis of the interplay between hydrodynamic and intermolecular forces. At permeate fluxes higher than 100 L/m2.h, 50-100% of PS particles were deposited by the end of filtration experiments, forming cake layers up to 9 particle diameters thick. In contrast, weak permeate drag forces corresponding to fluxes below 50 L/m2.h (i.e., just beyond the critical flux) resulted in insignificant deposition. Backwash fluxes from 15 to 57 L/m2.h exhibited negligible differences in the release of deposited particles owing to only a little increase in backwash drag force. Two mechanisms were observed for the release of NPs during backwash: i) complete release in small circular areas (diameter ≤2 µm) for thin deposits and ii) fracturing of the cake layer for thick deposits. For weathered NPs, irreversible deposition on the membrane surface was observed, although potential particle aggregation and polydispersity must be accounted for to obtain truly quantitative results. The successful quantification of particle deposition and release showcases LIBD as an effective method for fundamental investigations on NP transport during membrane filtration.