14 September 2021 in Physical Review Fluids
The coalescence of two nanobubbles (NBs) in water is a process of great importance to many industrial applications. In this work, we study the coalescence of two equal-sized nitrogen NBs in water using molecular dynamics (MD) simulations and continuum-based theoretical analysis. We vary the NB diameter from 30 to 50 nm and study the coalescence characteristics including the expansion speed of the capillary bridge between two coalescing NBs, the dynamic regime of NB coalescence, the diameter of fully merged NBs, and the temperature variation of NBs during the coalescence process. For all cases, we show the MD simulation results can be well understood by the theoretical models developed in this work. Due to the large Laplace pressure in the model NBs, the diameter ratio of fully merged NBs to their daughter NBs is , which explains the recent experimental result showing that the size of NBs in water is distributed discretely with a uniform increment factor of [Ma et al., J. Phys. Chem. B 124, 5067 (2020)]. The expansion of gas inside the coalescing NBs and the heat transfer between the gas NB and surrounding liquid leads to fluctuations of gas temperature during coalescence. From the theoretical analysis, we find the coalescence dynamics of NBs is in the crossover regime where neither viscous stress nor inertial stress in the surrounding liquid dominates even when the viscous stress is more than ten times higher than inertial stress. In the range of Ohnesorge number from 0.33 to 0.82, we show the scaling exponent for the capillary bridge radius vs time at late times of NB coalescence is around 0.75 ± 0.05, which is considerably higher than 0.5 in the viscous-dominated regime.
8 May 2020 in The Journal of Chemical Physics
There are two possible thermal transport mechanisms at liquid–gas interfaces, namely, evaporation/condensation (i.e., heat transfer by liquid–vapor phase change at liquid surfaces) and heat conduction (i.e., heat exchange by collisions between gas molecules and liquid surfaces). Using molecular dynamics (MD) simulations, we study thermal transport across the liquid–vapor interface of a model n-dodecane (C12H26) under various driving force conditions. In each MD simulation, we restrict the thermal energy to be transferred across the liquid–vapor interface by only one mechanism. In spite of the complex intramolecular interactions in n-dodecane molecules, our modeling results indicate that the Schrage relationships, which were shown to give accurate predictions of evaporation and condensation rates of monatomic fluids, are also valid in the prediction of evaporation and condensation rates of n-dodecane. In the case of heat conduction at the liquid–vapor interface of n-dodecane, the interfacial thermal conductance obtained from MD simulations is consistent with the prediction from the kinetic theory of gases. The fundamental understanding of thermal transport mechanisms at liquid–gas interfaces will allow us to formulate appropriate boundary conditions for continuum modeling of heating and evaporation of small fuel droplets.
1 December 2020 in Physics of Fluids
In this work, we use molecular dynamics (MD) simulations coupled with continuum-based theoretical analysis to study the coalescence dynamics of two equal-sized nanobubbles (NBs). We first derive a governing equation for the evolution of the capillary bridge radius between two coalescing NBs from the axisymmetric Navier–Stokes equation. To verify the prediction from the governing equation, we carry out MD simulations of the coalescence of two NBs in a Lennard-Jones fluid system and directly measure the bridge radius, rb, as a function of time, t. By varying the bubble diameter, we change the NB Ohnesorge number from 0.46 to 0.33. In all cases, we find the theoretical prediction overestimates the expansion speed of the capillary bridge at early time of NB coalescence. However, once we take into account the curvature-dependent surface tension and restrict the minimum principal radius at the capillary bridge to the size of the atom in the model liquid, the theoretical prediction agrees with the MD data very well in both early time and later time of the coalescence process. From the theoretical model, we find neither liquid viscous force nor liquid inertial force dominates at later time of coalescence of the model NBs. In this case, the MD simulation results show rb(t) ∝ t0.76 ± 0.04 with the scaling exponent considerably higher than that in the scaling law rb(t) ∝ t0.5 for the viscous and inertial dominated regimes. The diameter ratio of fully merged NB to that of the original NB is about , which is different from for the coalescence of millibubbles and microbubbles.
5 October 2020 in Physical Review E
In this work, we use the kinetic theory of gases (KTG) to develop a theoretical model to understand the role of internal motions of molecules on the maximum evaporation flux from a planar liquid surface. The kinetic theory is applied to study the evaporation of molecular fluids into a vacuum and predict the dimensionless maximum evaporation flux (, i.e., the ratio of the maximum evaporation flux to the molar flux emitted from a liquid surface). The key assumptions regarding the velocity distribution function (VDF) of polyatomic molecules in the highly nonequilibrium vapor near the evaporating surface are validated by the VDF obtained directly from molecular dynamics (MD) simulations. Our KTG-based analysis shows that is affected by the specific heat () associated with internal degrees of freedom of fluid molecules. When the maximum evaporation flux is reached, the isotropic evaporating vapor far from the liquid surface moves at its speed of sound regardless of whether it is a monatomic vapor or polyatomic vapor. To fundamentally understand the evaporation of a molecular fluid into a vacuum, we solve the Boltzmann transport equation (BTE) to obtain the temperature, density, and flow speed distributions in the highly nonequilibrium evaporating vapor flow. Our BTE solutions indicate that there are several universal features of the evaporating vapor when the maximum evaporation flux occurs. In particular, we find that the evaporating vapor flow speed reaches the maximum value of times the most probable thermal speed in the vapor flow direction at the vacuum boundary, and this maximum value is independent of fluid properties. All theoretical predictions in this work are verified by the MD simulation results of the evaporation of the model liquid Ar and the model liquid -dodecane into a vacuum, and existing experimental data.
1 January 2022 in Physics of Fluids
The aggregation of fine or ultrafine particles in liquid due to the nanobubble (NB) bridging capillary force is a key process for many industrial applications. The magnitude and direction of the NB capillary force (NBCF) are directly affected by the geometry of the NB gas bridge between two adjoining particles. Although the NBCF can be accurately measured using experimental techniques, it is very challenging to monitor the images of a NB capillary bridge in nanoscale spatial resolution in NBCF measuring experiments. As a result, the capillary force model that predicts the dependence of the NBCF on the geometry of the NB bridge has never been explicitly verified using experimental means. In this work, molecular dynamics (MD) simulations are carried out to study the NBCF between two parallel plates. MD simulations can readily measure both the NB bridge geometry and the resulting NBCF, which allows us to explicitly verify the predictions from the capillary force model. Our modeling results show that the capillary force model gives a good prediction of the NBCF for both concave and convex NB capillary bridges. Furthermore, with the assumption of constant contact angle and number of gas atoms inside the capillary bridge, we develop an improved capillary force model, which predicts the variation of the bridge geometry and the NBCF with the separation between two parallel surfaces. The continuum predictions from the improved capillary force model are corroborated by the MD simulation results and are consistent with the existing experimental data on NBCFs between two solid surfaces.