4 October 2022 in IEEE Open Journal of Power Electronics
The development trend of power converter is high frequency, high efficiency and high-power density. Compared with silicon-based power devices, SiC MOSFET has been widely used because of its fast-switching speed, low switching loss and high operating temperature. However, voltage spikes and oscillations are easy to occur during the high-speed turn-off of devices, which will seriously threaten the safe operation of power electronic converters. To solve this problem, based on the detailed analysis of the device turn-off process, a closed-loop active gate driver circuit based on dv/dt voltage feedback is proposed. Based on the small signal analysis of control oriented MOSFET driver circuit, the stability of dv/dt control is studied, and the influence of key parameters of driver circuit on the stability of control system is analyzed. The experimental results show that compared with the conventional gate driver, the proposed active gate driver can effectively suppress the peak voltage in the turn-off process without significantly increasing the switching loss.
30 December 2021 in IEEE Transactions on Plasma Science
The requirements of the toroidal field magnet coil in HT-6M Tokamak are that the peak value of output current is large and the pulse width is narrow, which is a typical pulse form. In order to meet the requirements, the scheme of capacitor energy storage pulsed power supply is designed. In the early stage, in order to verify the rationality of power supply design, a prototype of the 500-kJ capacitor energy storage pulsed power supply is developed. In this article, the transient processes of power supply are analyzed in detail by establishing a mathematical model. The power parameters are calculated according to output requirements, and the function relationships between the power input and output are obtained, and the theoretical analysis is proved by simplorer simulations. At the same time, the key devices of the power supply and short circuit protection are analyzed and designed, the prototype is developed, and the design requirements can be met by experiments.
19 October 2022 in IEEE Transactions on Plasma Science
The anode power supply is very important to the stability of the output wave power of the electron cyclotron resonance heating (ECRH) system. In order to improve the stability and anti-interference ability of the anode power supply, the small-signal analysis and controller design of the anode power supply are carried out in this article. First, the anode power supply is simplified and equivalent. Then, the LCC resonant circuit and the linear amplification circuit are established, respectively, for detailed analysis and research, and the small-signal models of these two parts are established. The transfer function of the whole system is obtained, the stability and rapidity of the anode power supply are analyzed, and the controller parameters are designed. Finally, the simulation model and prototype are built. The experimental results show that the system has better dynamic response ability and anti-interference ability after adding the controller.