This work covers different aspects of additive manufacturing of Nitinol parts. Firstly, requirements for the powder material and guidelines for the powder preparation are described in detail because the use of proper powder is essential for additive processing of high quality parts. Next, this work presents examples for Nitinol actuators, smart structures and devices which are produced by additive manufacturing. By demonstrating the functionality of these parts (e.g. shape recovery behavior after deformation), this work clearly points out a high potential for additive manufacturing of Nitinol. Moreover, additive manufacturing might even be able to open up new perspectives for Nitinol devices that have yet to be imagined.
15 September 2021 in Advanced Engineering Materials
Layer‐by‐layer additive manufacturing (AM) by means of laser‐powder bed fusion (L‐PBF) offers many prospects regarding the design of lattice structures used, for example, in gas turbines. However, defects such as bulk porosity, surface roughness, and re‐entrant features are exacerbated in nonvertical structures, such as tilted struts. The characterization and quantification of these kinds of defects are essential for the correct estimation of fracture and fatigue properties. Herein, cylindrical struts fabricated by L‐PBF are investigated by means of X‐ray computed tomography (XCT), with the aim of casting light on the dependence of the three kinds of defects (bulk porosity, surface roughness, and re‐entrant features) on the build angle. Innovative analysis methods are proposed to correlate shape and position of pores, to determine the angular‐resolved surface roughness, and to quantify the amount of re‐entrant surface features, q. A meshing of the XCT surface enables the correlation of q with the classical surface roughness Pa. This analysis leads to the conclusion that there is a linear correlation between q and Pa. However, it is conjectured that there must be a threshold of surface roughness, below which no re‐entrant features can be build.